FLI5962, FLI5962H,
FLI5968H, FLI5928H
Multi-function LCD monitor controllers up to WUXGA
Data brief
Features
■ Triple ADC and PLL up to 205 MHz
■ Integrated Ultra-Reliable DVI® receiver up to
165 MHz (FLI5962 and FLI5962H)
■ Integrated HDMI 1.1 receiver up to 165 MHz
(FLI5968H and FLI5928H)
■ HDCP supported with FLI59xxH versions
■ ITU656 video input
■ ITU601 (16-bit) video input
■ Variable PIP window up to 640 x 480
■ DCDi Edge® processing
■ MADi, film mode detection, temporal noise
reduction and cross color suppression for
SDTV
■ Response Time Compensation (RTC)
■ Frame Rate Conversion (FRC)
ITU656
VBI Parsing
ITU601
(FLI5962
only)
HDMI Rx
HDCP
Test Pattern
Generator
Analog Front End
Tripple ADC
Sync Slicer
Processing
Test Pa ttern
Generator
Sync
Processor
GPIO's
VBI
Interna l Microprocessor Bus
Clock
Generation
Embedded
Micro-
processor
SPI Seri al PROM Inte rface
PIP Channel
Input Processor
Input
Format
Measureme
nt
Main Channel
Input Processor
VCR
Trick Mode
Detection
ROM
Low Bandwidth Analog Inputs
RAM
Low
Bandwidth
ADC
16-bit TTL
HDMI
YPrPb /
RGB Inputs
H Sync
V Sync
General
Purpose Input /
Outputs
Video
Input
■ Panoramic scaling for wide output resolutions
■ TV color controls using ACC and ACM-3D
■ Faroudja® Truelife
™
horizontal enhancements
■ Versatile OSD controller for high quality
bitmap-like TV OSD
■ Embedded x86 microprocessor with external
SPI Flash ROM
■ Dual LVDS transmitter for direct interconnect to
LCD panels up to WUXGA 60 Hz
■ Package: 256 PQFP
Applications
■ Multi-function LCD monitors up to WUXGA
resolutions
■ Mid-range LCD TVs with PC and HDTV
connectivity
PIP Image
Processing
Separate H & V
3x3 Matrix
De-interlacer
DCDi
Temporal Noise
Scaling
(TNR)
Motion
Detection
Reduction
Film Mode
Image Enhancement
ACC/ACM-II or
ACM-3D
3x3 Matrix
HDMI Audio
Interface
(FLI5968/28
only)
SPDIF
Four I2C
Adaptive
De-interlacing
SDR Memory Interface
Controller
(CCR)
(MADi)
Reduction
Cross Color
PWM
PWM
Interfac e
External
Memory
Display Processing
Separate H & V
Scaling
Variable Zoom
Scaling
Horizontal Edge
Enhancement
(HEM)
Aspect Ratio
Conversion
Response Time
Compensation
Two-wire
Serial
Master 1
Two-wire
Interface
OSD
Controller
Two-wire
Serial
Master 2
Two-wire
Interfac e
Controller
PIP Blender
OSD Overlay
DDC2bi
Slave 1
DDC2bi
Slave 2
Dual
LVDS
Tx
Output
Formatter
LVDS
Output
24-bit
TTL Output
DDC2bi
Interfac e
DDC2bi
Interface
April 2010 Doc ID 15018 Rev 2 1/7
For further information contact your local STMicroelectronics sales office.
www.st.com
7
Description FLI5962, FLI5962H, FLI5968H, FLI5928H
1 Description
The FLI59xx family of controllers are highly integrated mixed signal LCD controllers for
multi-function LCD monitors and LCD TV applications supporting up to WUXGA resolutions.
The FLI59xx has integrated advanced video image processing from Faroudja as well as a
proven ADC/PLL and Ultra-Reliable DVI or HDMI 1.1 compatible digital receiver with FRC to
ensure proven PC graphics compatibility.
With Emmy award winning Faroudja DCDi® technology incorporating horizontal
enhancement technology, advanced TV color control with Adaptive Contrast and Color
(ACC) and Active Color Management-3D (ACM-3D), in addition to industry leading Motion
Adaptive De-interlacing (MADi), advanced film mode detection, and response time
compensation, the FLI59xx processes SDTV inputs to output images that are crisper with
life-like quality.
The integrated picture-in-picture, embedded microcontroller, versatile OSD engine, low
bandwidth general purpose ADC, and dual LVDS transmitters (or optional 24-bit TTL output)
enables cost-effective HDTV-ready multi-function LCD monitor or LCD TV solutions.
The FLI59xx family of controllers includes the following products:
● FLI5962 supports up to 1920 x 1200 resolutions with DVI
● FLI5962H supports up to 1920 x 1200 resolutions with DVI and HDCP
● FLI5968H supports up to 1920 x 1200 resolutions with HDMI and HDCP
● FLI5928H supports up to 1366 x 768 resolutions with HDMI and HDCP
Figure 1. System diagram
Composite
S-Video
YPbPr
VGA
DVI/HDMI
Decoder
(Optional)
Video
ADC
ITU656
FLI59xx
SPI ROM
1Mx16
1Mx16
LVDS to Panel
NVRAM
Keypad with IR
2/7 Doc ID 15018 Rev 2
FLI5962, FLI5962H, FLI5968H, FLI5928H Feature attributes
2 Feature attributes
● Dual analog input
– Operation up to 205 MHz
– Dual RGB inputs
– Single RGB and single YPbPr up to 1080i inputs
– Bi-level and tri-level analog sync support and Macrovision™ support
– Dual HSYNC, VSYNC, and SOG inputs
● Ultra-Reliable DVI/HDMI 1.1 input
– HDMI 1.1, DVI 1.0, and HDCP 1.1—operates up to 165 MHz
– Receives and outputs 2 to 8 channels of digital audio up to 192 KHz. Four
programmable I2S and one SPDIF output
● Digital video input
– ITU656 video input support for commercially available video decoder
– ITU601 (16-bit) video input support for external MPEG2 decoder, DVI Rx, and
ADC
● High quality advanced scaling engine
– Independent and programmable horizontal and vertical scaling factors
– Panoramic scaling (non-linear)
– Variable sharpness settings
● Picture-in-Picture (PIP)
– Variable PIP window size up to 640 x 480
– Video PIP on Graphics or Graphics PIP on Video
– Independent PIP window color controls
● Frame rate conversion
– 16-bit/32-bit data path to support single or dual 1Mx16 SDR SDRAM
– Full frame rate conversion up to SXGA 75 Hz
● Faroudja video processing and color control
– MADi for SDTV
– Inverse 3:2/ 2:2 pull down for film mode detection for SDTV
– DCDi Edge processing for SDTV
– Temporal Noise Reduction (TNR) up to 720p
– Cross color reduction
– Faroudja TrueLife horizontal enhancement
– ACC, ACM-II, and ACM-3D
● Response time compensation
– Compensates motion blur that results from slow response time of LCD panels—
resulting in motion image that is clean and crisp
● OSD controller
– Up to 4 windows
– 1, 2, or 4-bits per pixel color
– Blinking, transparency, blending, and proportional fonts support
Doc ID 15018 Rev 2 3/7
Feature attributes FLI5962, FLI5962H, FLI5968H, FLI5928H
● Output support up to WUXGA 60 Hz
– Dual-channel LVDS transmitters with pin swap for flexibility in PCB layout
– Optional 24-bit TTL output
● System-on-chip integration for lower BOM
– On-chip reset circuit with integrated Schmitt trigger for HSYNC and VSYNC
– Embedded x86 MCU with serial interface
– General-purpose low-bandwidth ADC
– Integrated gamma and 3x3 LUT for sRGB compliance
– ESM® and boundary scan support
4/7 Doc ID 15018 Rev 2
FLI5962, FLI5962H, FLI5968H, FLI5928H Ordering information
3 Ordering information
Table 1. Order codes
Part number Description
FLI5962-LF-AA 256-pin PQFP
FLI5962H-LF-AA 256-pin PQFP
FLI5928H-LF-AA 256-pin PQFP
FLI5968H-LF-AA 256-pin PQFP
In order to meet environmental requirements, ST offers these devices in different grades of
ECOPACK
specifications, grade definitions and product status are available at: www.st.com.
ECOPACK
®
packages, depending on their level of environmental compliance. ECOPACK®
®
is an ST trademark.
Doc ID 15018 Rev 2 5/7
Revision history FLI5962, FLI5962H, FLI5968H, FLI5928H
4 Revision history
Table 2. Document revision history
Date Revision Changes
25-Sep-2008 1 Initial release.
Updated template and ECOPACK statement.
Updated Figure 1. System diagram.
Added all RPNs to title.
22-Apr-2010 2
Added Doc ID.
Removed references to FLI5922H.
Minor wording corrections to Description and Feature attributes
sections.
6/7 Doc ID 15018 Rev 2
FLI5962, FLI5962H, FLI5968H, FLI5928H
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any
time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any
liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2010 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com
Doc ID 15018 Rev 2 7/7
Loading...