ST FL-101 User Manual

Features

■ Allows PC or Notebook parallel port to program

UPSD and PSD devices using PSDsoft
Express software development tool.

■ Supports IEEE 1149.1 JTAG signals (TCK,

TMS, TDI, TDO).

■ Supports additional signals (TERR and

TSTAT) to reduce programming time.

■ Single FlashLINK cable assembly supports

both 3.3 V and 5 V target devices with no
manual configuration. Target device may
operate from 2.7 V to 5.5 V.

■ Flying Lead cable included to adapt to any

target connector using 0.025" square posts.

■ Loop Test cable included to validate PC

parallel port operation.

Table 1. Device summary

Reference Order code

FL-101

FlashLINK JTAG Programmer

Data brief

Description

The FL-101 is a FlashLINK JTAG programming
cable for PSD and UPSD microcontroller fa milies.
Driven by a PC through a parallel port, it allows
In-System Programming (ISP) of PSD an d UPSD
devices located on an application b oard.

FlashLINK JTAG Programmer FL-101

October 2011 Doc ID 022303 Rev 1 1/3

For further information contact your local STMicroelectronics sales office .

www.st.com

3

Ordering information FL-101

Ordering information

The FL-101 can be ordered from your nearest ST distributor or sales office (ST orde r code:
FL-101).

For more information and complete documentation, please refer to the STMicroelectronics
microcontroller support site on www.st.com.

Revision history

Table 2. Document revision history

Date Revision Changes

03-Oct-2011 1 Initial release.

2/3 Doc ID 022303 Rev 1