EVALSPEAr600
Evaluation board for SPEAr600 embedded MPU
Data brief
Features
■ SPEAr600 embedded MPU
■ Up to 2 Gbits DDR2 333 MHz (std 128 MB)
■ Up to 16 MB Serial Flash (std 8 MB)
■ Up to 2 Gb NAND Flash (std 64 MB)
■ 4 Kb Serial I
■ Two USB 2.0 full Host port channels
■ One USB 2.0 HS Device
■ 10/100/1000 Ethernet port
■ Two serial ports (up to 115 Kbaud)
■ Debug ports (JTAG + ETM9)
■ 8 ADC channels (10 bit, 1 Msamples)
■ 10 GPIOs
■ LCD I/F up to 24 bits-per-pixel (bpp)
Figure 1. EVALSPEAr600 evaluation board
2
C
■ Additional 112 GPIOs when the external FPGA
is used
Description
The EVALSPEAr600 evaluation board allows you
to quickly evaluate and debug software for the
SPEAr600. It acts as a learning tool to rapidly get
familiar with the SPEAr600 features and provides
a starting point for the development of the final
application board. It is equipped with most of the
interfaces offered by the SPEAr600.
It is equipped with all the interfaces offered by the
SPEAr600. A special version of the board
populated with an FPGA also exists for
developing customer-specific IPs.
September 2010 Doc ID 18020 Rev 1 1/3
For further information contact your local STMicroelectronics sales office.
www.st.com
3
Revision history EVALSPEAr600
Revision history
Table 1. Document revision history
Date Revision Changes
20-Sep-2010 1 Initial release.
2/3 Doc ID 18020 Rev 1
EVALSPEAr600
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any
time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any
liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2010 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com
Doc ID 18020 Rev 1 3/3
Loading...