
Dual line IPAD™, common mode filter with
ESD protection for high speed serial interface
Features
■ Very large differential bandwidth above 5 GHz
■ High common mode attenuation:
- 23 dB at 900 MHz.
■ High common mode attenuation:
- 20 dB between 800 MHz and 2.2 GHz.
■ Very low PCB space consumption: <1.1mm
Thin package: 0.50 mm max. after reflow
■
■ Lead-free package
■ High reduction of parasitic elements through
integration
2
ECMF02-2BF3
Data brief
Flip Chip
5 bumps
Figure 1. Pin configuration (bump side)
12
Complies with the following standard:
■ IEC 61000-4-2 level 4 input and output pins:
– ±15 kV (air discharge)
– ±8 kV (contact discharge)
Application
High speed serial interfaces such as USB2.0,
MIPI D-PHY, MDDI and HDMI.
Description
The ECMF02-2BF3 is a highly integrated
common mode filter designed to suppress
EMI/RFI common mode noise on high speed
differential serial buses like MIPI D-PHY, MDDI,
USB2.0 and HDMI.
The ECMF02-2BF3 can protect and filter one
differential lane.
IN1
IN2
GND
OUT1
OUT2
A
B
C
TM: IPAD is a trademark of STMicroelectronics.
February 2012 Doc ID 022765 Rev 1 1/3
For further information contact your local STMicroelectronics sales office.
www.st.com
3

Revision history ECMF02-2BF3
1 Revision history
Table 1. Document revision history
Date Revision Changes
01-Feb-2012 1 Initial release.
2/3 Doc ID 022765 Rev 1

ECMF02-2BF3
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any
time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY TWO AUTHORIZED ST REPRESENTATIVES, ST PRODUCTS ARE NOT
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any
liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2012 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com
Doc ID 022765 Rev 1 3/3