Features
■ High surge capability to comply with
GR-1089 and ITU-T K20/21
■ Stand-off voltage: 5 V, 8 V, 10 V
■ Low capacitance device
■ RoHS package
■ Low leakage current: 0.5 µA at 25 °C
Complies with the following standards
■ Telcordia GR-1089
– 2.5 kV 2/10 µs - 500 A 2/10 µs
– AC power fault tests
■ ITU-T K20/21/45
– 6 kV 10/700 µs - 150 A 5/310 µs
– power induction tests
– power contact tests
■ IEC 61000-4-2, level 4
– 15 kV (air discharge)
– 8 kV (contact discharge
■ MIL STD 883G-Method 3015-7: Class 3
– 25 kV (human body model)
DSL02
Secondary protection for xDSL lines
Data brief − production data
SOT23-5L (SC-59)
Figure 1. Functional diagram
I/O1
I/O2
I/O2
I/O1
I/O2
Description
DSL02 is designed to protect DSL line drivers
against surges defined in worldwide
telecommunication standards. This device
protects line drivers of various systems such as
ADSL and VDSL. The low capacitance makes it
suitable from ADSL to VDSL data rates.
DSL02 is able to survive severe conditions even
when used with downgraded or oscillating gas
tube.
DSL02 is packaged in a SOT23-5L.
June 2012 Doc ID 023174 Rev 1 1/3
This is information on a product in full production. For further information contact your local STMicroelectronics sales
office.
www.st.com
3
Ordering information DSL02
1 Ordering information
Table 1. Ordering information
Order code Marking Package Weight Base qty Delivery mode
DSL02-005SC5 YT05
SOT23-5L 16 mg 3000 Tape and reelDSL02-008SC5 YT08
DSL02-010SC5 YT10
2 Revision history
Table 2. Document revision history
Date Revision Changes
04-June-2012 1 Initial release.
2/3 Doc ID 023174 Rev 1
DSL02
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any
time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY TWO AUTHORIZED ST REPRESENTATIVES, ST PRODUCTS ARE NOT
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any
liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2012 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com
Doc ID 023174 Rev 1 3/3
Loading...