ST CCA018V1 User Manual

digital audio line driver based on the TS4657
Power supply range: 3 V to 5.5 V
Audio line output: 2.2 V
range
16 to 24-bit audio data format stereo DAC, 32
to 48 kHz sample rate
2
I
S, right or left justified compatible digital
audio interface
95 dB SNR A-weighted at 48 kHz, V
7.4 mA current consumption at V
operation
Internal negative power supply to ensure
ground-referenced, cap-less outputs
No external capacitor needed for the negative
power supply generation
Integrated structure to suppress pop and click
noise
Standby mode active low
RoHS compliant
Description
for entire VCC
RMS
CC
= 3 V, full
CC
= 5 V
STEVAL-CCA018V1
Single-supply stereo
Data brief
STEVAL-CCA018V1
The digital audio data can be 16 to 24-bits long and sample rates from 32 to 48 kHz are supported.
The output stage signal is ground-referenced by using an internal self-generated negative power supply, so bulky external output coupling capacitors are not necessary.
The STEVAL-CCA018V1 demonstration board is designed provide a platform for evaluating the performance of the TS4657 stereo digital-to analog-converter (DAC). The TS4657 integrates a high-performance audio line driver capable of generating a 2.2 V
output level from a single
RMS
3.0 to 5.5 V supply.
A single supply is sufficient for the digital and analog parts of the circuit, eliminating the need for external regulators.
The TS4657 is a low consumption device, with only 22 mW of power dissipation at 3.0 V power supply during full operation.
A 16-bit multi-bit sigma-delta DAC is used, operating at 256xFs with over sampling digital interpolation filters.
October 2009 Doc ID 16593 Rev 1 1/4
For further information contact your local STMicroelectronics sales office.
www.st.com
4
Schematic diagram STEVAL-CCA018V1

1 Schematic diagram

Figure 1. Circuit schematic

C
CA
V
VCCD
C2
3
C
1
F
1u
uF
C5
C4
1u
1
F
uF
14
18
19
nc20nc
Interface
13
VCCD
VCCA
l
Digi
ta
Digital
ters
Fi
l
Audio
and
DACs
TS4657
VREGD
VREGA
VOUT
VOUTR
IC1
1
2
L
11
C6
2nF2
JP4
nc
R6
820 R5
JP
5
JP7
R7
820
nc
R8
J6 SIP2
OUT L
OUT R
J7 SIL2
JP6
C7
2nF2
2
K
DAT
Control
Interface
DigitalInput
SDAT
MCLK
LRCLK
B
J
5
VCCDVCCA
10uF/6V3
C
1
R1
100KR2100KR3100KR4100K
3
LRCL
4
S
5
BCLK
6
MCLK
3v to 5V5
VCC
N
D
G
J
4
J
3
J2
CLK
J1
VCCD
123
JP1
FORMAT18FORMAT2
7
123
JP2 Format2Format1 /Stdb
UserControl
/STDBY
9
123
JP3
GNDD
GNDA
GNDA15GNDA
GNDD
Epad
1
10
16
17
y
Output Filters
2/4 Doc ID 16593 Rev 1
STEVAL-CCA018V1 Revision history

2 Revision history

Table 1. Document revision history

Date Revision Changes
29-Oct-2009 1 Initial release.
Doc ID 16593 Rev 1 3/4
STEVAL-CCA018V1
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY, DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2009 STMicroelectronics - All rights reserved
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
STMicroelectronics group of companies
Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com
4/4 Doc ID 16593 Rev 1
Loading...