ST AN1778 Application note

AN1778

APPLICATION NOTE

STR7

ARM MULTI-ICE SETUP

INTRODUCTION

This application note describes how to set up the Mul ti-ICE debug interfac e target when accessing it for the first time. The following paragraph describes the Multi-ICE interface and ICE server setup. It assumes that the ICE tool software has been installed. Ensure that the RealView Debugger software is installed first before installing the Multi-ICE software.

The Ice interface unit should be connected to your workstation and to the target hardware. Refer to the Debug man agem ent section in the getti ng started doc ument for m ore details on the host to the STR7 board connection. The application board must be powered on.

MUTLI-ICE SETUP

Follow this procedure to setup Multi-Ice as a target interface for the debugger:

■

Ensure that Multi-ICE software is installed on the host machine. For details on Multi-ICE software installation, refer to the Multi-ICE instal lation guide.

■

Connect the Multi-ICE interface to the host machine through a Parallel Port cable and to the target board through a JTAG cable. Then switch on the power to the target board.

■

Select Start->Programs->ARM Multi-Ice v2.2 from the Windows Start menu,

■

Select Multi-ICE Server from the menu. AR M Multi-ICE server is started.

■

Select File->Auto-Configure from the window main menu and wait until the server has examined the target.

If the configuration succeeds, the contents of the window look like this:

For further details on Multi-ICE configuration, refer to the Multi-ICE user guide.

Rev. 1.0

AN1778/0104 1/2

STR7 ARM MU LT I-ICE SETUP

“THE PRESENT NOTE WHICH IS FOR GUIDANCE ONLY AIMS AT PROVIDING CUSTOMERS WITH INFORMATION REGARDING THE IR PRO DUCT S IN OR DER FO R THEM TO SAV E TIME . AS A RES ULT, STMIC ROEL ECTR ONI CS SHALL NOT BE HELD LIABLE FOR ANY DIRECT, INDIRECT OR CONSEQUENTIAL DAMAGES WITH RESPECT TO ANY CLAIMS ARISING FROM THE CONTENT OF SUCH A NOTE AND/OR THE USE MADE BY CUSTOMERS OF THE INFORMATION CONTAINED HEREIN IN CONNECTION WITH THEIR PRODUCTS.”

Information furnished is believed to be accurate and reliable. However, STMicroelectronics assumes no responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is granted by implic ation or oth erwise unde r any patent or patent r i ghts of STMi croelectroni cs. Speci fications me ntioned in this publicat i on are subject to change without notice. This publication supersedes and replaces all information previously supplied. STMicroelectronics products are not authorized for use as critical components in life su pport device s or systems without express written approval of STMicroelectronics.

The ST logo is a register ed t rademark of ST M i croelectroni c s.

All other nam es are the pro perty of their respective ow ners

STMicroelectron i cs GROUP OF COMPANIES

Australi a – B el gium - Brazi l - Canada - China – Czech Rep ubl i c - Finland - France - German y - Hong Kong - Indi a - Israel - Ital y - Japan -

Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States

www.st.com

2/2