ST AC7MDT10-D20, AC7MDT10S20 User Manual

AC7MDT10-D20/S20

DIP20/SO20 Connection Kit for ST7MDT10-EMU3

DATA BRIEF

The DIP20/SO20 Connection Kit (AC7MDT10-

D20/S20) provides the hardware you need to
connect your ST7MDT10-EMU3 emulator to your
application when debugging applications for ST7
microcontrollers in DIP20 and SO20 packages.

Connection Kit Contents

■ DIP20 adapter (DB482A) – Allows the

connection of your ST7MDT10-EMU3 emulator
to your application board in place of your ST7.

■ DIP20-DIP20 device adapter (DB535) –

Adapts the pin out of the DIP20 adapter to the
DIP20 footprint of the ST7 on your application
board.

■ DIP20-SO20 device adapter (DB093) –

Adapts the DIP20 adapter to SO20 footprint of
the ST7 on your application board.

For more information...

■ ST7-EMU3 User Manual – Information

common to all EMU3 series emulators

■ ST7MDT10-EMU3 Probe User Guide –

Information specific to ST7MDT10-EMU3

Figure 2. DIP20 adapter, DIP20 device adapter

DIP20 adapter (D B482A)

DIP20 device adapter
(DB535)

Figure 3. DIP20 application board connection

2. Plug the DIP20 adapter

into the W1 connector on the
target emulation board of your
ST7MDT10-EM3.

3. Align pin 1 indicators, then

insert the pins of the DIP20
adapter into the DIP20-DIP20
device adapter.

4. Align pin 1 indicators, then

insert the pins of the DIP20­DIP20 device adapter into the
socket on the application
board.

Pin 1

Indicators

Figure 1. DIP20 adapter

DIP20 adapter (DB586)

Application board

1. Solder socket on to the

application board.

Note: The pinout on the DIP20 adapter is askew by 90°

from the microcontroller. You use the DIP20 to
DIP20 device adapter between the flex adapter
and the socket on your application board when
emulating MCUs in DIP20 package.

Rev 1

November 2005 1/3

www.st.com

3

AC7MDT10-D20/S20

Figure 4. DIP20 adapter, SO20 device adapter and application board connection

DIP20 adapter (DB482A)

2. Plug the DIP20 adapter into

the W1 connector on the target
emulation board of your

DIP20-SO20 device
adapter (DB093)

1. Solder the connection pins to your

application board in place of your MCU. When
soldering, insert the connection pins into the
device adapter, which serves as a support to
ensure correct alignment.

3. Align pin 1 indicators, then

insert the pins of the DIP20
adapter into the DIP20-SO20
device adapter.

ST7MDT10-EM3.

Pin 1

Indicators

Revision history

Date Revision Changes

14-November-2005 1 Initial release.

Application board

2/3