WP-RG3S10 - Ranger XP Powered Sub Box
Tools Needed For Installation
Drill with 1/4" Drill Bit
Phillips Screwdriver / Cordless drill
T-25 Torx Wrench
Wire Crimpers / Strippers
Installation Instructions:
First you will need to remove the factory under seat storage compartment
on the passenger side, and remove the 3 Torx bolts as shown
Using the 6 M6x1.0 screws and washers provided, attach the 2 brackets
as shown
This enclosure will mount under the passenger seat, replacing the under seat storage compartment of the Ranger XP900, if
you have a Ranger XP900 crew it can mount under either the front or the rear passenger seat area.
You can now place the enclosure in position under the seat and re-install
the factory Torx Bolts, use the included "self-tapping" screw for the final
hole location on the lower left bracket. Plug the input connector to the amp
out connector from the overhead unit.
CORPORATE: SSV WORKS, 201 N Rice Ave, Unit A, Oxnard, CA 93030
Phone: 1-818-991-1778 Web: www.SSVworks.com
The installation of the enclosure portion is now complete, Step 10 begins the wiring
10) Cut the power/ground cable to length, be sure to leave enough wire at the battery location to wire to the
battery, strip back approximately 4 inches of the black tubing to expose the red/black wires inside
11) Strip back 1/4"-1/2" of wire to make your connections
12) Crimp the supplied fuse holder onto the end of the RED wire and attach to the battery "+" terminal
13) Crimp the supplied ring terminal to the BLACK wire and attach to the battery "-" terminal
Your connections are now complete, refer to the user guide for proper use of the system.
Loading...