SSV Works WC-FKP65 Installation Instructions Manual

WC-FKP65 - Wildcat Front Kick Panel

Tools Needed For Installation

Drill with 1/4" Drill Bit
7/16 Open End Wrench

5/32 Allen Wrench

Wire Crimpers / Strippers

Installation Instructions:

Align the speaker panel on the flat side of the footwell
and mark the 4 holes

After marking the holes, drill them using a 1/4" drill bit

Drill a hole through the top of the pod for your speaker
wire

Once the holes are drilled, mount the kick panel using the
supplied hardware the nut will go on the inside of the kick
panel

After securing all the allen bolts and the 7/16 nuts run
your speaker wire into the speaker pod and attach
terminals. Then attach the terminals to the speaker.

After attaching the speaker wires to the speaker install the
speaker into the SSV Works kick panel.

Install the protective gill over the speaker, repeat for the
other side

CORPORATE: SSV WORKS, 19528 VENTURA BLVD. #158 TARZANA, CA 91356
WEB: www.SSVworks.com FAX: [phone]