SRS Light Design WPSU240-8, WPSU480-8, WPSU600-8 Instruction Manual

WPSU600/480/240

Scroller power supply

with optional Wireless DMX

Instruction Manual

Model:
WPSU240-8 240W power
WPSU480-8 480W power
WPSU600-8 720W power

ATTENTION!

This instruction manual contains important information about
the installation and use of equipment. Please read and follow
these instructions carefully. Always ensure that the power to
equipment is disconnected before opening the equipment or
commencing any maintenance work.

SRS Light Design s.r.o, Rybničná 36/D , 831 06 Bratislava, Slovak Republic tel:[phone],
fax:[phone], www.srslight.com , [e-mail]

IMPORTANT SAFETY INFORMATION

The following general safety precautions have to be observed during all phases of
operation, service, and repair of this equipment. Failure to comply with these precautions
or with specific warnings in this manual violates safety standards of design, manufacture,
and intended use of this equipment.

Do not operate in an explosive atmosphere !

Do not operate this equipment in the presence of flammable gases or fumes. Operation of
any electrical instrument in such an environment constitutes a definite safety hazard.
Device should never be placed near or over heat register or any other source of heated
air and it should not be installed or operated without proper ventilation.

Mains AC 90-265V connection

AC power is connected to the splitter via Neutrik PowerCon blue connector. Standard
supply is UNISCHUKO lead with Neutrik PowerCon. Always respect markup of L and N on
connector for correct wiring of Line and Neutral.

DMX connection

DMX connectors are located on left front side of scroller power supply. There are both
3way and 5way Neutrik fitted in. Last WPSU in line should be terminated by the
termination resistor of 120ohm operated by switch close to the DMX in/out.

There is DATA LED indication for DMX data presence in device. When operating device in
Wireless DMX mode, the lost of radio signal will cause the device automatically switch to
the cable mode; Cable can be used as backup of Wireless DMX line. Received Wireless
DMX signal is not present on the DMX in/out connectors at all time.

Pin 1 Data Common
Pin 2 Data -
Pin 3 Data +

SRS Light Design s.r.o, Rybničná 36/D , 831 06 Bratislava, Slovak Republic tel:[phone],
fax:[phone], www.srslight.com , [e-mail]

Front panel:

WPSU600:

WPSU480:

WPSU240:

On the front panel, there is red POWER indication LED for the power supply state. There is
also DATA LED for DATA indication. DATA LED is ON, when DMX signal is connected to the
device or it is received by Wireless DMX.

Wireless DMX is operated separately from W-DMX module. Top button is MODE button and
is used for ON/OFF operation of wireless part.

Bottom W-DMX button is used for operation as Link/Unlink from the Wireless DMX transmitter.