Squareled SPIRIT User Manual
SquareLED - SPIRIT
Manual | SPIRIT
1.Mechanical Specication
Manual | SPIRIT
2. Introduction
Unpacking:
Thank you for purchasing the SPIRIT Battery Bar. Every SPIRIT Battery Bar has been thoroughly tested and has
been shipped in perfect operating condition.Carefully check the shipping carton for damage that may have
occurred during shipping. If the carton appears to be damaged, carefully inspect your xture for any damage and
be sure all accessories necessary to operate the unit has arrived intact.
Introduction:
The SPIRIT Battery Bar is the newest revolutionary battery powered and main supply wireless controlled colour
changer with 8 powerful RGBW full color LEDs.This light can be used in a stand alone mode or connected in a
Master/Slave conguration. Our rechargeable battery pack xture, is particularly suitable for events where set up time is problematic, and the passage of cables is hard. Setup and conguration of the xture by touch control
panel.
Warning!
To prevent or reduce the risk of electrical shock or re, do not expose this unit to rain or moisture.
Caution!
There are no user serviceable parts inside this unit. Do not attempt any repairs yourself, doing so will avoid your
manufactures warranty. In the unlikely event your unit may require service please contact us.
The battery life is one year.
PLEASE recycle the carton when ever possible.
Manual | SPIRIT
3. Safety Information
Installation
Make sure all parts for xing the projector are in a good state of repair. Make sure the point of anchorage is
stable before positioning the projector.
The safety chain must be properly hooked onto the tting and secured to the framework, so that,if the
primary support system fails, the tting falls as little as possible. If the safety chain gets used,it needs to be
replaced with a genuine spare.
Minimum distance of illuminated objects
The projector needs to be positioned so that the objects hit by the beam of light are at least 0.2 metres (8”)
from the lens of the projector.
Minimum distance from ammable materials
The projector must be positioned so that any ammable materials are at least 0.20 metres (8“) from every
point on the surface of the tting.
Mounting surfaces
It is permissible to mount the tting on normally ammable surfaces.
Maximum ambient temperature
Do not use the project if ambient temperature (Ta) exceeds 40°C.
IP65 protection rating
The equipment is fully protected against dust (rst digit 6) and against jets of water (second digit 5).
Protection against electrical shock
Connection must be made to a power supply system tted with ecient earthing (Class I appliance according to standard EN 60598-1). It is, moreover, recommended to protect the supply lines of the projectors
from indirect contact and/or shorting to earth by using appropriately sized residual current devices.
Connection to the power mains
A qualied electrician must perform connection to the power mains. Check that the mains frequency and
voltage correspond to the frequency and voltage for which the projector was designed and indicated on
the electrical data label. This label also gives the input power.Refer to the latter to evaluate the maximum
number of devices to be connected to the mains to avoid overloads.
Maintenance
Before starting any maintenance work or cleaning the projector, cut o power from the supplymains. After
switching o, do not remove any parts of the tting for at least 10 minutes. The lensesmust be mounted
and, if visibly damaged, they have to be replaced with genuine spares.
Battery
This product contains a lithium iron tetraphosphate rechargeable battery. To protect the environment,
please discard the battery at the end of its life cycle according to current 40°Claw.
Manual | SPIRIT
The products referred to in this manual conform to the European Community Directives to which
they are subject: • Low Voltage Directive 2006/95/EC
• Electromagnetic Compatibility Directive 2004/108/EC
4. Product Overview
Manual | SPIRIT
5. Technic 5. Technical Data
• Source: 8x 8W LED RGBW 4 in 1
• Led power: 64W
• Optics:
Secondary optic lens,with 25 degree
Head adjustmen: 0-90°
• Cooling: Natural cooling by body
• Control:
Wireless DMX,Master, Slave and sound,auto mode
Wirless module: WDMX from sweden
• User interface:
LCD display with four buttons
Nice battery indicator from 25-100
Wirless indicator for connection
• External power:
full range 100-240V 50-60Hz, WEIPU connector,
for both battery charge and normal operations
• Body
Die cast aluminium
2 bracket
• Protection rating: IP65
• Battery:
8 hours for full on
Color change and dimming with 16 hours
Quality lithum battery
• Working position: Outdoor use
• Dimension: 635 X 171.27 X 208.8 mm
• N.W: 9 KG
• G.W: 12 KG
Manual | SPIRIT
6. Operating Instructions
Loading...