Square D ATV212HD15N4 Data Sheet

Speed range 1…10

Speed accuracy +/- 10 % of nominal slip 0.2 Tn to Tn

Torque accuracy +/- 15 %

Transient overtorque 120% of nominal motor torque +/- 10 % 60 s

Asynchronous motor control profile Flux vector control without sensor, standard

Regulation loop Adjustable PI regulator

Motor slip compensation Automatic whatever the load

Local signalling DC bus energized 1 LED red)

Output voltage <= power supply voltage

Isolation Electrical between power and control

Type of cable Without mounting kit 1 IEC cable 113°F (45°C), copper 90 °C / XLPE/EPR

Electrical connection VIA, VIB, FM, FLA, FLB, FLC, RY, RC, F, R, RES terminal 0.00in² (2.5mm²) / AWG 14

Tightening torque 5.31lbf.in (0.6N.m) VIA, VIB, FM, FLA, FLB, FLC, RY, RC, F, R, RES)

Supply Internal supply for reference potentiometer (1 to 10 kOhm) 10.5 V DC +/- 5 %, <10A overload and

Analogue input number 2

Analogue input type VIA switch-configurable voltage 0...10 V DC 24 V max 30000 Ohm 10 bits

Sampling duration 2ms +/- 0.5 ms F discrete

Response time FM 2 ms +/- 0.5 ms analog

Accuracy +/- 0.6 % VIA) for a temperature variation 60 °C

Linearity error VIA +/- 0.15 % of maximum value input

Analogue output number 1

Analogue output type FM switch-configurable voltage 0...10 V DC 7620Ohm 10 bits

Discrete output number 2

Discrete output type Configurable relay logic FLA, FLC) NO - 100000cycles

Minimum switching current 3mA 24 V DC configurable relay logic

Maximum switching current 5A 250 V AC resistive cos phi = 1 L/R = 0 ms FL, R)

Discrete input type F programmable 24 V DC level 1 PLC 4700 Ohm

Discrete input logic Positive logic (source) F, R, RES), <= 5 V, >= 11 V

Voltage/frequency ratio, 2 points
Voltage/frequency ratio, automatic IR compensation (U/f + automatic Uo)
Voltage/frequency ratio - Energy Saving, quadratic U/f
Voltage/frequency ratio, 5 points

Not available in voltage/frequency ratio motor control
Adjustable

Without mounting kit 1 IEC cable 113°F (45°C), copper 70 °C / PVC
With UL Type 1 kit: 3 wire(s)UL 508 cable at 40°C, copper 75 °C / PVC

L1/R, L2/S, L3/T terminal 0.04in² (25mm²) / AWG 3

39.83lbf.in (4.5N.m), 40 lb.in L1/R, L2/S, L3/T)

short-circuit protection
Internal supply 24 V DC 21…27V), <200A overload and short-circuit protection

VIB configurable voltage 0...10 V DC 24 V max 30000 Ohm 10 bits
VIB configurable PTC probe 0...6 probes 1500 Ohm
VIA switch-configurable current 0...20 mA 250 Ohm 10 bits

2ms +/- 0.5 ms R discrete
2ms +/- 0.5 ms RES discrete

3.5ms +/- 0.5 ms VIA analog
22ms +/- 0.5 ms VIB analog

FLA, FLC 7 ms +/- 0.5 ms discrete
FLB, FLC 7 ms +/- 0.5 ms discrete
RY, RC 7 ms +/- 0.5 ms discrete

+/- 0.6 % VIB) for a temperature variation 60 °C
+/- 1 % FM) for a temperature variation 60 °C

VIB +/- 0.15 % of maximum value input
FM +/- 0.2 % output

FM switch-configurable current 0...20 mA 970Ohm 10 bits

Configurable relay logic FLB, FLC) NC - 100000cycles
Configurable relay logic RY, RC) NO - 100000cycles

5A 30 V DC resistive cos phi = 1 L/R = 0 ms FL, R)
2A 250 V AC inductive cos phi = 0.4 L/R = 7 ms FL, R)
2A 30 V DC inductive cos phi = 0.4 L/R = 7 ms FL, R)

R programmable 24 V DC level 1 PLC 4700 Ohm
RES programmable 24 V DC level 1 PLC 4700 Ohm

Negative logic (sink) F, R, RES), >= 16 V, <= 10 V

2