BLITZ 2 IN 1 FOOD PROCESSOR
INSTRUCTION MANUAL
BEFORE OPERATING THIS UNIT, PLEASE READ THE FOLLOWING INSTRUCTIONS.
SQPC 8244 14-11-2018
SQPC 8244 14-11-2018 | SQ Professional Ltd © 2019 All rights reserved
BLITZ 2 IN 1 FOOD PROCESSOR INSTRUCTION MANUAL
PROCESSOR PARTS
2
1 Blender Jug Cap
2 Blender Jug Lid
3 Blender Jug
4 Push Cover
5 Feed Tube
6 Bowl Cover
7 Processor Bowl
8 Drive Shaft
9 Safety Interlocks
10 Base Unit
11 Speed Control
12 Pulse Button
13 Slicing Blade
14 Shredding Blade
15 Blade Disc
16 Mixing Blade
17 Chopping Blade
18 Blade Retainer
12
13
14
15
16
17
18
11
10
4
5
7
6
1
9
2
9
3
SPECIFICATION
Rated Voltage ....... 220-240V
Frequency .....................50Hz
Power ......................... 700W
IMPORTANT!
Due to sharp parts and potential hazards the appliance is
not suitable for the use of children under 8 years old. Even
when o please keep the appliance and cord out of the reach
of children. Children over 8 must be supervised by an adult
at all times when using or cleaning the appliance. This is not
a toy! The appliance can be used by persons with reduced
physical, sensory or mental capabilities if they have been
given supervision and instruction and understand the use
and hazards involved.
8
All images are for illustration purposes only. Actual products may vary.
SAFEGUARDS
BLITZ 2 IN 1 FOOD PROCESSOR INSTRUCTION MANUAL
3
This product has been designed for domestic
use only. The manufacturer will not accept
any responsibility, and the warranty will not
apply for any commercial or inappropriate
use, or failure to comply with the instructions.
When using any electrical appliance, basic safety
precautions should always be applied including
the following:
1 Read all instructions before using.
2 Do not leave parts of packaging (plastic bags,
foam polystyrene, screws, etc.) within reach
of children or incapable persons as they are
potential sources of danger.
3 To protect against risk of electrical shock do
not put the unit in water or any other liquid.
4 Make sure the data on the appliance rating
plate corresponds to that of the main power
supply and of your electrical system before
plugging into the outlet. In case of doubt,
contact professionally qualied personnel.
5 It is advisable not to use adapters, multiple
plugs and extensions. If absolutely necessary,
use devices certied and conforming to
existing safety standards, making sure they
are compatible with your electrical system
and with the appliance technical data.
6 Close supervision is necessary when any
appliance is used around children. Do not
allow children or incapable persons to use
the appliance.
7 Any installation not conforming to instructions
may endanger your safety and forfeit the
warranty.
8 Unplug from the socket when the appliance
is not in use, before putting on or taking o
parts, and before cleaning.
9 Avoid contact with moving parts.
10 Do not operate any appliance with a damaged
cord or plug, or after the appliance is dropped
or damaged in any manner. Return the
appliance to the nearest authorised service
facility for examination, repair or mechanical
adjustment.
11 Never leave your appliance to operate
unattended.
12 Do not use outdoors or leave the appliance
exposed to atmospheric agents (sun / rain)
13 Do not use the appliance with bare feet or
wet hands or feet.
14 Do not let the cord hang over the edge of a
table or counter.
15 Keep hands and utensils out of the jug
whilst blending to reduce the risk of severe
injury to persons or damage to the food
processor. A spatula may be used but only
when the food processor is not running.
16 Handle the metal blade and discs with great
care: they are extremely sharp.
17 Do not switch on the food processor when it
is empty.
18 Ensure the cover is securely locked in place
before operating the the food processor.
19 This appliance is manufactured to conform
to the Low Voltage Electrical Equipment
(Safety) Regulations 1989 and is designed to
comply with BS 3456. It complies with the
requirements of the EEC Directive (89/336/
EEC). Any connection error will render the
warranty void.
20 Always use the push cover to push food down
the feeder tubes, never use your ngers, a
fork, a spoon, a knife or other utensils.
21 Use the accessories one at a time.
22 Only remove the accessories when the
appliance has come to a complete stop.
23 SQ Professional Ltd may not be held liable
for eventual damages to persons, animals
or objects caused by incorrect installation
or deriving from improper, erroneous or
unreasonable use.
24 The maximum duration for continuous
operation of the appliance is 40 seconds, the
appliance must rest for 30 minutes before
restarting. Thus after ve 40 second periods,
the appliance should be rested for 1 hour.
SAVE THESE INSTRUCTIONS
IMPORTANT SAFEGUARDS
SQPC 8244 14-11-2018 | SQ Professional Ltd © 2019 All rights reserved
BLITZ 2 IN 1 FOOD PROCESSOR INSTRUCTION MANUAL
OPERATION DIAGRAMS
4
M
BLENDING
F G H I
SLICING & SHREDDING
A B C ED
CHOPPING
Food Processing
LJ K
All images are for illustration purposes only. Actual products may vary.
USE & CARE
BLITZ 2 IN 1 FOOD PROCESSOR INSTRUCTION MANUAL
5
USING YOUR BLITZ FOOD
PROCESSOR FOR THE FIRST TIME
Before attaching or removing any parts, make
sure the power cord is unplugged from the
power outlet and speed dial is in the ‘O’ position.
Prior to rst use, wash all the parts that come
into contact with food with warm soapy water
and dry thoroughly (see section on Cleaning &
Storage).
ALWAYS TAKE CARE WHEN HANDLING THE
BLADES AS THEY ARE VERY SHARP.
Operating Instructions
Follow the instructions below to achieve the
best results and to keep your appliance in good
working condition.
• Do not exceed the recommended maximum
quantities.
• Do not pour liquids hotter than 75°C into
the bowl and/or blender.
• Do not leave the appliance unattended
while it is on.
• Do not switch the appliance on while it is
empty.
• Do not touch the moving parts.
• Do not put your ngers or utensils inside
the jug or blender when it is operating.
• Do not press down the ingredients into
the lid opening with your hands. Use the
push cover.
• Do not use the appliance to process
ingredients that are hard (e.g. frozen
meat, inedible parts of ingredients such
as bones and pips), rubbery or sticky (e.g.
candied orange peel).
• Always switch o the appliance and wait
for it to stop completely before removing
the lid or changing accessories.
• Always remove the blade from the processor
bowl before removing the ingredients.
Food Processing
CHOPPING FUNCTION
Suitable for single stage cake mixes, kneading
butter into our, adding water to mixtures and
chopping, puréeing and whisking.
1 Place the drive shaft (8) on the base unit
(10), attach the processor bowl (7) and turn
the handle in a clockwise direction to lock it.
(
operation diagram a
)
2 Mount the blade retainer (18) on the drive
shaft (8) in the middle of the processor
bowl (7). (
operation diagram b
)
3 Fix the stainless steel blade (17) on the
rotor. Warning! The blade is very sharp.
Please only hold the plastic part.
4 Place ingredients into the processor bowl
(7). Large pieces of food should be cut into
2cm cubes rst. (
operation diagram c
)
5 Place the bowl cover (6) on the processor
bowl (7), and turn it until it clicks and locks.
(
operation diagram d
)
6 Plug the mains cable into the electric
socket. Rotate the Speed Control (11) to the
desired speed. (
operation diagram e
)
7 To use the short, powerful impulse
movement, press the PULSE button (12)
and hold for the desired time. When the
PULSE button is released the appliance
immediately stops working.
8 When you have nished chopping, turn
the Speed Control (11) to “0”. When the
processing has nished, open the bowl
cover (6), and carefully remove the stainless
steel blade (17) and then the food.
WHISKING FUNCTION
Suitable for beating egg whites, mixing egg and
sugar and whipping cream.
The whisking function has the same operating
steps as the chopping function. Simply replace
the stainless steel blade (17) with the plastic
blade (16). (
operation diagram b
)
SQPC 8244 14-11-2018 | SQ Professional Ltd © 2019 All rights reserved
BLITZ 2 IN 1 FOOD PROCESSOR INSTRUCTION MANUAL
USE & CARE
6
SLICING & SHREDDING FUNCTION
Suitable for processing rm foods such as carrots
and hard cheeses and softer foods such as
tomatoes and cucumbers.
1 Attach the processor bowl (7) as described
above. (
operation diagram a
)
2 Slide the slicing (13) or shredding blade
(14) onto the blade disc (15) and place it on
the blade retainer (18). (
operation diagrams f
and g
)
3 Place the bowl cover (6) on the processor
bowl (7), and turn it until it clicks and locks,
and plug the appliance into the electric
socket. Select the desired speed. (
operation
diagram h
)
3 Food should be cleaned and cut into pieces
that t into the feed tube (5). Push the food
down slowly and use the push cover (4) to
push it down all the way. (
operation diagram i
).
Blending
1 Ensure that the blender is unplugged then
remove the drive shaft (8), place the blender
jug (3) on the base unit (10) and turn the
handle in a clockwise direction to lock it.
(
operation diagrams j and k
)
2 Place ingredients into the blender jug (3)
and cover with the blender jug lid (2). When
correctly closed the lid activates the safety
lock (9). If the lock is not activated, the
blender will not operate. (
operation diagrams
l and m
)
3 Plug the appliance into the electric socket and
rotate the Speed Control (11) to select the
desired speed or use the PULSE button (12).
4 To add liquids to remove the blender jug cap
(1) and slowly pour the liquid into the jug.
5 Switch the appliance o by turning the
Speed Control (11) to “0” and pour the
contents out of the blender jug.
FOOD
PROCESSING
INGREDIENTS MAX QUANTITY
MAX PROCESSING TIME
SLICING SHREDDING
SLICING
POTATOES
500g 60s 60sMELON
CARROT
CHOPPING
&
WHISKING
MEAT 500g
50sHAM 400g
ONIONS 500g
STRAWBERRIES 300g 45s
EGGS 10 yolks
40s
CHEESE
200g
ALMONDS
HAZELNUTS
WALNUTS
BLENDING
APPLES
300g 40-50s
ORANGES
GRAPES
STRAWBERRIES
INGREDIENTS SHOULD BE CUT TO CUBES,
MAX. 2 x 2 x 2 cm / PIECE
WATER VOLUME: 450ml
All images are for illustration purposes only. Actual products may vary.
USE & CARE
BLITZ 2 IN 1 FOOD PROCESSOR INSTRUCTION MANUAL
7
Cleaning
1 Always unplug from the power outlet
before cleaning.
2 Clean the base unit (10) with a soft, slightly
damp cloth.
Do not wash it under running water and
do not submerge it in water or any other
liquid.
3 All the accessories can be washed by hand
or in the dishwasher. Use warm water and
mild washing up detergent when handwashing.
Take extra care when handling the steel
blades.
4 Accessories can be placed in the upper
part of the dishwasher but make sure
that the water never exceeds a maximum
temperature of 50°C.
5 Do not use chemical or abrasive substances
on any parts.
NOTE
• When you have nished cleaning, check that
the safety interlocks (9) are not obstructed
by residue. If necessary, use a soft brush to
clean the appliance whilst it is still unplugged
from the mains.
• The blades cannot be sharpened.
• Contact an authorised Service Centre for
maintenance work on your appliance.
Storage
• Make sure that your appliance and all its
accessories are completely dry before
putting them away.
• Your food processor has a space-saving
storage system where all accessories can be
put away tidily in the bowl.
ATTENTION!
To avoid damages, never use the appliance
while the accessories are still inside.
Wiring UK plugs
Should the power cable or the power plug
become da maged, arrange for these to be
replaced by Customer Servi ce or qualied
person before continuing to use the appliance.
The product is tted with a 13A BS1362 fuse in
a 13A BS 1363 plug.
Disposal & Environmental
protection
To avoid environmental and health problems
due to hazardous substances in electrical and
electronic goods, appliances marked with this
symbol must not be disposed of with unsorted
municipal waste. Please recycle with your local
electrical waste centre.
Service
The product is not user serviceable. If it is not
working, read the instructions, check the plug
fuse and main fuse/circuit breaker. If it is still
not working, consult your retailer.
If that does not solve your problem, ring
Customer Services - they may be able to oer
technical advice.
If they advise you to return the product to us,
pack it carefully, include a note with your name,
address, day phone number, and description of
the problem.
If under a warranty, say where and when it was
purchased and include proof of purchase. Send
it to SQ Professional Ltd.
WARRANTY
THE WARRANTY FOR THIS PRODUCT IS COVERED BY SQ PROFESSIONAL LIMITED. ANY
FAULTS WITH THIS PRODUCT ARISING THROUGH A MANUFACTURER DEFECT WILL BE
COVERED FOR 1 YEAR FROM THE DATE OF PURCHASE, SUBJECT TO A VALID PROOF
OF PURCHASE BEING PRESENTED. THIS DOES NOT INCLUDE FAULTS OR DAMAGE
CAUSED BY MISUSE OF GENERAL WEAR AND TEAR.
PLEASE CONTACT CUSTOMER SERVICES ON 01992 716 070, MONDAY TO FRIDAY
FROM 09:30 - 17:30 OR SEND AN E-MAIL TO INFO@SQPROFESSIONAL.COM.
THIS DOES NOT AFFECT YOUR STATUTORY RIGHTS.
Voltage Business Centre, Units 1 - 3 | 6 Mollison Avenue, Eneld, EN3 7XQ
T: 01992 716 070 | F: 01992 700 538
E: info@sqprofessional.com | W: www.sqprofessional.com
SCAN THE QR CODE TO DISCOVER THE ENTIRE
RANGE OF SQ PROFESSIONAL PRODUCTS.
Loading...