Spytec Water Resistant HD Video Watch Quick Start Manual

Water Resistant HD Video Watch

Quick start guide

www.spytecinc.com

Getting Started with Your New Watch

1. Plug in the USB cord to your PC or Mac in order to
fully charge the watch. While charging the watch, a
blue light will blink indicating that the watch is charg­ing. The watch is fully charged when the blue light
becomes solid.

2. Hold down the button located on the bottom left for
two seconds until a blue/red light illuminates on the
front of the watch. After 1 to 2 seconds, the red light
will turn o and the blue light will go steady, indicat­ing that the camera is in standby mode.

Using the Video Recording Feature

1. While the watch is in standby mode, press and release
the button located on the bottom left. A blue light on
the front of the watch will blink three times and shut
o, indicating that the watch is now recording video.

2. To stop the recording, press the same button again
and the blue light will flash three times, indicating
that the recording has stopped.

Using the Camera Feature

1. While the watch is in standby mode, press and release
the button located on the top left. A solid red light will
illuminate on the front of the watch for one second.
When the blue light returns, this indicates that the
image was taken.