SPT WA-1030E, WA-1030H, WA-1030M, WA-1230E, WA-1230H Instruction Manual

`

It is important that you read
these instructions before
using your new purchase
and we strongly recommend
that you keep them in a safe
place for future reference.

Portable Air Conditioner / Heater

Your Guarantee

If this product is found to be faulty as a result of faulty materials or workmanship

within one year from date of purchase, it will be repaired or replaced free of charge.

This guarantee is subject to the following terms:

SPTUSA, must be notified of the fault.

Proof of purchase must be presented to SPTUSA’s nominated representative.

The warranty will be void if the product is modified, misused or repaired by an

unauthorized person.

The guarantee after repair or replacement will not be extended beyond the

original one year period.

All replacement parts or units will be new or reconditioned.

Parts or units, which are replaced, become the property of SPTUSA.

The warranty applies to the use of this product in the United States.

Warranty does not include freight charges.

This GUARANTEE is in addition to your Statutory Rights.

Dear Customer: Please keep this warranty for your record. DO NOT return it.

14

Instruction Manual

For Models WA-1030E, WA-1030H, WA-1030M

WA-1230E, WA-1230H

P O R T A B L E

Air Conditioner

`

13 1

Maintenance

Thank You!

Always unplug the unit from the mains before be ginning the cleaning.

Cleaning the Housing

Use a soft, damp cloth to wipe the body clean.
Never use strong chemicals, oil-based products, detergents, chemically treated
cloths or other cleaning solutions. These could possibly damage the cabinet.
Important! Clean the exhaust air intake area (located on the right side, near
bottom) with a vacuum to remove dust accumulation. Excessive dust may
cause a decrease in performance and/or damage to the compressor. Damage
caused by improper maintenance will void the warranty.

Cleaning the Filter

Use a vacuum cleaner or tap the filter lightly to remove loose dust and dirt from the
filters and then rinse them thoroughly under running water (no hotter than 104°F)
do not wet the activated carbon filter, remove from frame before washing.
Dry thoroughly before replacing.

Notice! Never operate the unit without the filters.

End of Season Storage

Unplug the unit.
Drain the condensed water COMPLETELY (please refer to
page 10). Clean or change the filter.
On a warm day, turn the unit to fan mode for a couple of hours so that the inside can dry out
completely. It is recommended that the unit be put back into its original carton for storage.
Do not stack heavy objects on top of the unit.

Storing The Power Cord

When the unit is not in use, please store the power cord away

as shown in Figure 3.

Thank you for choosing the portable air conditioner from SPTUSA, a leading
brand in indoor air treatment. We would like you to enjoy the many benefits
this unit offers, so please take the time to read this manual carefully and take
full advantage of the many advanced features that your SPTUSA Air Conditioner
offers you. SPTUSA has specialized in complete indoor environment control,
manufacturing world-class air conditioners, dehumidifiers and air purifiers
with innovative technology. In designing these advanced products , we have
listened carefully to our customers and have passed their views on to our
research and development laboratories.
We wish you many years of enjoyable use.
After reading this manual, please keep it in a safe place for future reference.

Energy Saving Tips

• Please use the unit in the recommended room size. (Refer SPECIFICATIONS).

• Do not locate the air conditioner where furniture or other objects can obstruct

the airflow.

• Keep blinds/curtains closed during the sunniest part of the day.

• Close the fireplace damper and floor or wall grills so that cool air does not

escape through the chimney or ductwork.

• Keep the filters clean.

Set the unit to maximum cooling and high speed fan initially, then adjust the
unit to a comfortable setting.

NOTE: It is recommended to turn on the air conditioner when the room
temperature is around 75˚F. Do not wait until th e room is excessively hot.

Fig. 3

`

11 4

Operation – Mechanical Models

Before Use

Setting the Temperature

Turn the THERMOSTAT to regulate the temperature you desire: range 64˚F to 90˚F.

Setting the Timer

Set the TIMER to the desired operating time (1 to 8 hours ).
When the set time has elapsed, the machine will shut off automatically.

Regulating the Airflow Direction

Turn the roller on the air vent to control the
airflow direction from the vertical louvers.

NOTICE!

• The compressor will start approximately 3 minutes after th e unit is turned
on (this will help prolong the life of the compress or). After switching the
unit off, please wait at least 3 minutes before turning the unit back on.

• The cooling system will switch off if the room temperature is lower than set.
The fan, however, keeps working at the set level. If the ambient te mperature
rises above the chosen level, the cooling will resume.

Important!

• Transport the unit in an upright position only, or leave it in an upright
position for at least 2 hours before first use.

• Always place the unit on an even surface (Figure 1).

• Make sure the unit is connected to a correctly grounded power supply

(refer to the rating label located at the back of the unit).

• An opening in a window or wall is required to accommodate the
exhaust hose (kit supplied) to expel the warm air.

• Do not cover or obstruct the appliance inlet or outlet grilles (Figure 2).

• To avoid the risk of shock, the product should never be used in

bathrooms, shower rooms or in any other steamy or wet areas.

• The unit will cool when the room temperature is between 64˚F and
110˚F depending on the thermostat setting.

• Do not sit or place objects on the unit.

• Do not touch the unit with wet/damp hands or when standing barefoot.

• Avoid all contact with chemical based materials.

• The filter must be used with the product at all times. When removing

for cleaning, always disconnect the unit from the mains first.

• Turn off the appliance when not in use.

• At the end of each season all water must be drained and the unit and

filters cleaned before storage.

• Drainage of the water container is required before moving the unit or
putting it into storage.

• If the electric socket is different from the plug provided, have a
professionally qualified electrician replace the plug with a suitable one.
Avoid the use of adaptor plugs, multiple sockets and/or extension
leads; if their use is necessary, ensure that they conform to the current
safety regulations.

unroll it completely to avoid the possibility of dangerous overheating.

• If the supply cord is damaged, it must be replaced by the service agent
or a similarly qualified person.

THE MANUFACTURER DISCLAIMS ANY RESPONSIBILITY IF THE
ABOVE INSTRUCTIONS ARE NOT FOLLOWED.

Fig. 1

Fig. 2