SPT IM-440C, IM-660C, IM-1108C Instruction Manual

IM-440C
IM-660C
IM-1108C

Thank you for selecting SPT Automatic Ice Maker!
To ensure the proper operation of this ice maker, please read the
instruction manual carefully before use and keep it in a safe place.

Electrical Requirements

Control Panel

6

Warranty

3-4

Ice Storage & Sounds

Storage

Disposal

6

8

8

· Do not connect or disconnect the electric plug with wet hands.

· Never clean the ice maker with ammable uids. These fumes can create a re hazard or explosion.
Do not store gasoline or other ammable vapors/liquids in the vicinity of this or any other appliance.

· Always turn unit off and disconnect power and water line before servicing.

· Replace all panels after servicing or maintenance.

· Do not attempt to repair or replace any part of the ice maker unless specically recommended by
the manufacturer. All other servicing should be referred to a qualied technician.

· Have two or more people to move and install this ice maker. Failure to do so may result in injury.

· Never install or operate the unit in an enclosed area, such as a closed cabinet. Choose a well­ ventilated area with temperatures between 50°F to 100°F. The unit MUST be installed in an area
protected from the elements, e.g., wind, rain, water spray or drips.

· Do not locate next to ovens, grills or other sources of high heat.

· The ice maker must be installed with all electrical, water and drain connections in accordance with
state and local codes.

· Do not kink or pinch the power supply cord between the ice maker and cabinet.

· The unit must be leveled in order to work properly.

· Make certain the pipes are not pinched or kinked or damaged during installation.

· Check for leaks after water line connection.

· Never allow children to operate, play with or crawl inside the ice maker.

· Although the unit has been tested at the factory, due to long-term transit and storage, the rst batches
of cubes must be discarded.

· Never turn the water supply tap off when the ice maker is working.

·Never tile the ice maker more than 45 degrees

·Be sure supplied water pressure is between 14.7-117 psi.

· If the ice maker has not been used for a long time, clean thoroughly before use. Follow instructions
provided for cleaning and sanitizing. Do not leave any solution inside the unit after cleaning.

· The plug must be accessible after installation.

· Do not use this appliance for other than its intended purpose.

· Do not touch the evaporator by hand when unit is operating.

· This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities or lack of experience and knowledge, unless they have been given supervision
/instruction concerning the use of this appliance by person responsible for their safety.

· Connect to a potable water supply only.

· If the supply cord is damaged, it must be replaced by the manufacturer, a service agent or similarly
qualied person in order to avoid a hazard.

· SAVE THESE INSTRUCTIONS.

1. Power Switch

2. Display Panel

3. Ice Maker Door

4. Shelf

5. Water Cabinet

6. Ice Full Sensor

7. Ice Storage Cabinet

8. Power Cord

9. Water Inlet

10. Screw for Drainage

11. Drain Outlet

12. Foot

Squeeze Hose Clamp