Page 1
IInnssttrruuccttiioonn M
Maannuuaall
ICE MAKER
It is important that you read these instructions before using your portable ice maker and we strongly
recommend that you keep them in a safe place for future reference.
Model: IM-100
Page 2
TABLE OF CONTENTS
IIMMPPOORRTTAANNTT SSAAFFEETTYY IINNSSTTRRUUCCTTIIOONNS
PPRREEPPAARRIINNGG YYOOUURR IICCEE MMAAKKEERR FFOORR UUSSEE
IMPORTANT SAFETY TIPS …………………………………………………………………..2
GGEETTTTIINNGG TTOO KKNNOOWW YYOOUURR UUNNIITT …………………………………………………………………………………………………………………………33
OPERATING PROCEDURES & MAINTENANCE
UNPACKING YOUR ICE MAKER …………………………………………………………….4
CONNECTING YOUR ICE MAKER …………………………………………………………..4
CLEANING AND MAINTAINING YOUR ICE MAKER ………………………………………4
UUSSIINNGG YYOOUURR IICCEE MMAAKKEER
TTRROOUUBBLLEESSHHOOOOTTIINNG
TTEECCHHNNIICCAALL PPAARRAAMMEETTEERRSS && DDEEFFEECCTTIIVVEE NNOOTTIICCEE
GGUUAARRAANNTTEEE
E ……………………………………………………………………………………7
R …………………………………………………………………….5
G ………………………………………………………………………….5
S …………………………………………………….1
……………………………………6
1
Page 3
DANGER
!
WARNING
!
IMPORTANT SAFETY INSTRUCTIONS
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual in regards to your appliance.
Always read and obey all safety massages.
This is the safety alert symbol:
!
All safety messages will follow the safety alert symbol and the word “DANGER” or “WARNING”.
These warnings mean:
You could be seriously injured if you don’t follow immediate instructions.
All safety messages will describe the potential hazard, inform you on how to reduce the chance of injury,
and indicate what can happen if instructions are not followed.
2
Page 4
PREPARING YOUR ICE MAKER FOR USE
IMPORTANT SAFETY TIPS
When using electrical appliances, basic safety precautions should be followed to reduce the risk of fire,
electric shock, and injury to persons or property. Read all instructions before using any appliance.
Do not operate this or any other appliance with a damaged cord.
Connect to properly polarized outlets only. No other appliance should be plugged into the same
outlet. Be sure that the plug is fully inserted into the receptacle.
Do not run cord over carpeting or other heat insulators. Do not cover the cord. Keep cord away from
traffic areas, and do not submerge in water.
We do not recommend the use of an extension cord, as it may overheat and become a risk of fire. If
you must use an extension cord, use No.14 AWG minimum size and rated no less than 1875 watts.
Unplug the ice maker before cleaning or making repairs.
Exercise caution and use reasonable supervision when appliance is used near children.
Do not clean your ice maker with flammable fluids. The fumes can create a fire hazard or explosion.
Do not tip over.
If the ice maker is brought indoors from outdoors during the wintertime, give it a few hours to warm
up to room temperature before plugging it in.
3
Page 5
2
B
A
1
4
3
6
5
GETTING TO KNOW YOUR UNIT
1. Cover: With a transparent window to allow interior visibility.
2. Control Panel: Easy to use, visible functions and 1-touch display setting.
A) Starts or stops ice making cycle.
B) Selects ice cube size.
3. Water drain cap: For draining water from water reservoir.
4. Ice basket.
5. Ice scoop.
6. Ice shovel.
4
Page 6
DANGER
OPERATING PROCEDURES & MAINTENANCE
UNPACKING YOUR ICE MAKER
!
CLEANING AND MAINTAI
NING YOUR ICE MAKER
1. Remove all exterior and interior packaging. Check that ice basket and ice scoop is included. If any
part or accessory is missing, please contact our customer service.
2. Clean the interior with lukewarm water and a soft cloth. Remove the ice basket and wash it in warm
water.
3. Find a location for your ice maker that is protected from direct sunlight and other sources of heat (i.e.:
stove, furnace, radiator). Place the ice maker on a level surface. Maker sure that there is at least 5
inches of space between the back and sides of your ice maker and the wall.
4. Allow one hour for the refrigerant fluid to settle before plugging in the unit.
5. The appliance must be positioned so that the plug is accessible.
CONNECTING YOUR ICE MAKER
* Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged please call our customer service.
1. This unit should be properly grounded for your safety. The power cord of this appliance is equipped
with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility
of electric shock.
2. Plug your appliance into an exclusive, properly installed, grounded wall outlet. Do not under any
circumstances, cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician.
3. This appliance requires a standard 120 volt, 60Hz electrical outlet with three-prong ground.
Before using your ice maker, it is strongly recommended to clean it thoroughly.
Remove the ice basket.
1. Turn the drain cap clockwise to drain out the water.
2. Clean the interior with diluted detergent, warm water and a soft cloth.
3. The outside of the ice maker should be cleaned regularly with a mild detergent solution and warm
water.
4. Dry the interior and exterior with a soft cloth.
5. Close the drain cap.
6. When the machine is not in use, open water drain cap to drain water completely from water reservoir.
5
Page 7
USING YOUR ICE MAKER
TROUBLESHOOTING
1. Clean your ice maker first.
2. Open the cover, remove the ice basket and pour water into tank.
Keep water level below the level mark.
3. Plug in the unit and the power indicator light will blink.
4. Press “Power” on the control panel to begin the ice making cycle. The power indicator light will lit.
5. Select the size of the ice cube by pressing the “Select” button. If ambient temperature is below 60°F,
it is recommended to select small or medium size to avoid ice sticking together.
6. The ice making cycle lasts 6 to 12 minutes, depending on the size of the ice cube selection.
7. While the icemaker is on, check water level periodically. If water pump can’t inject water, the ice
maker will stop automatically, and the “Water” indicator will be on.
Press “Power” button, fill water up to the level mark and press “Power” again.
Allow 3 minutes for the refrigerant to settle before restarting.
8. The ice maker automatically stops working when the ice basket is full.
9. Change water in the water reservoir every 24 hours to ensure a reasonable hygiene level.
If unit is not in use, drain all water in the tank reservoir.
PROBLEM POSSIBLE CAUSE
“Water” indicator is on.
“Ice” indicator is on.
“Water” and “Ice” indicator
are both flash.
Ice cubes stick together.
Ice making cycle is normal
but no ice is made.
SOLUTION
Water is low.
Ice basket is full. Remove ice from ice basket.
Ice shovel is stuck.
Ice making cycle is too long.
Water temperature in inner
tank is too low.
Ambient temperature or
water temperature in inner
tank is too high.
Refrigerant liquid leakage. Consult a qualified technician.
Pipe in the cooling system is
blocked.
Stop the ice maker, fill water, and
restart.
Check if ice is blocking the ice
shovel, otherwise, consults a
certified technician.
Stop the ice maker, and restart
when the ice blocks melt. Select the
small ice size.
Change the water in the reservoir.
Use water between 45°F- 90°F.
Please operate the ice maker below
ambient temperature of 90°F and
use cold water.
Consult a qualified technician.
6
Page 8
TECHNICAL PARAMETERS
SPECIFICATION
MMooddeell
PPrrootteeccttiioonn TTyyppee
PPoowweerr
RRaatteedd CCuurrrreenntt
PPoowweerr CCoonnssuummppttiioonn
RReeffrriiggeerraanntt
NNeett WWeeiigghhtt
SSiizzee
IIMM--110000
II
112200VV // 6600HHzz
11..2255AA
220000WW
RR113344aa//112200gg
4466llbbss
1177”” HH xx 1155”” WW xx 1177 11//88”” LL
Defective Notice
If this product is defective or not working properly
Please DO NOT return to your retail store
Please contact us directly with any Service or Technical Assistance
Contact us toll free at:
1-800-330-0388
7
Page 9
ICE MAKER
Your Guarantee
If this product is found to be faulty as a result of faulty materials or workmanship
within one year from date of purchase, it will be repaired or replaced free of charge.
This guarantee is subject to the following terms:
USA
SPT
, must be notified of the fault.
Proof of purchase must be presented to SPT
USA
’s nominated representative.
The warranty will be void if the product is modified, misused or repaired by an
unauthorized person.
The guarantee after repair or replacement will not be extended beyond the original
one-year period.
All replacement parts or units will be new or reconditioned.
Parts or units, which are replaced, become the property of SPT
USA
.
The warranty applies to the use of this product in the United States.
Warranty does not include freight charges.
Note : For service, please call Sunpentown Int’l Inc. at
800-330-0388 or visit www.spt-usa.com
This GUARANTEE is in addition to your Statutory Rights.
Dear customer, please keep this warranty for your record – DO NOT return to Sunpentown Int’l Inc.
Loading...