Springer Controls N5 Technical Data
22MM (N5) OILTIGHT PILOT DEVICES
TECHNICAL DATA
General Specifications
G
22
Conformity to Standards UL508 (USA)
NEMA ICS-2 (USA)
VDE 0600 (Germany)
BSI (Great Britain)
CEI EN60947.5.1 (Italy)
CENELEC EN 5000 7 (Europe)
Approvals UL listed - File Number E170195
Manufacturing Facility is registered to ISO 9000
Finger Protection at Terminals IP2X according to IEC 529
Terminal identication is registered to ISO 9000
Enclosure Ratings Suitable for use in NEMA Types 1, 3, 3R, 3S, 4, 4X, 12 and 13 enclosures. (Multi-function push buttons are suitable for
NEMA Type 1 enclosures only unless used with protective rubber cap accessory.) IP66 per IEC529, when mounted in
enclosures with equal or superior seal.
Ambient Temperature Operating
-13º to +158ºF
-25º to +70ºC
Climate Suitability / Humidity Climate Type
Temperature
Wet
Hot Wet
Variable Wet
Resistance to Vibration Per IEC 68-2-6, 16g with a frequency from 40-500 Hz and maximum peak-to-peak amplitude of 0.75mm
Resistance to Shock According to MIL 202B, method 202A. Test was performed for 1/2 sinusoid for 11md, 38g max for all operators with
transformers and 100g for all other operators.
Operating Force Standard push button operator: 2.5lbs (11N). Each contact block: 1.3lbs (6N).
Selector switch operator: 2.4in/lb (0.27Nm)
CSA C22.2 No. 14-M91 (Canada)
IEC 947.5.1 (International)
UTE (France)
NFC 63140 (France)
JIS (Japan)
Storage
-40º to +158ºF
-40º to +70ºC
Temperature
74ºF (23ºC)
74ºF (23ºC)
104ºF (40ºC)
74º to 104ºF (23º to 40ºC)
Relative Humidity
50%
83%
92%
83% to 92%
Wire Terminals
Suitable for #22 - #12 AWG stranded or solid copper wires, single or parallel conductors of same size.
Terminal torque: 7-12 in/lb. Parallel conductor size combinations (stranded or solid wire):
Parallel Conductor Size Combinations
(Stranded or Solid Wire)
Wire Capacity and Terminal Torque
Requirements
Quick Connect Terminals Suitable for one female tab connector measuring 0.25 x 0.03 inches (6.35 x 0.8 mm) or two female tab connectors mea-
suring 0.11 x 0.03 inches (2.8 x 0.8 mm).
#12 with #14
#14 with #16
#16 with #18
#16 with #20
#16 with #22
#18 with #22
#18 with #20
#20 with #22
Terminal Torque
12 in/lb
12 in/lb
12 in/lb
12 in/lb
12 in/lb
10 - 12 in/lb
10 - 12 in/lb
7 - 12 in/lb
G22
Contact Data
Electrical Reliability Data Electrical life and reliability in low level current: 80 million operations at 12V, 5mA, resistive load.
Dust Resistance In extremely dusty environments, electrical life at low level current is 250,000 operations at 12V, 5mA, resistive load.
Thermal Current lth = 10A per IEC 947-5-1
Insulation Voltage Ui = 660 Volts ac/dc (opposite polarity) except 2NO and 2NC blocks 300 Vac/dc
Protection from Electrical Shock Class I per IEC 536 for metal operators
Insulation Category Group “C” per VDE 0110
Dielectic Strength 2500 volts
Short Circuit Protection 10A type G fuse, per IEC 269.1 & 269.3
Pilot Duty Ratings
(32 contacts tested successfully for 2.5 million operations).
In a clean environment, electrical life at low level current is 10 million operations at 12V, 5mA, resistive load.
Class II (double insulation) per IEC 536 for plastic operators
A600 (maximum make volt-amperes = 7200; maximum break volt-amperes = 720; PF- .25)
Volts (AC - V)
Continuous (A)
Making (A)
Breaking (A)
Q300 (maximum make or break vold-amperes = 69)
Volts (DC - V)
Continuous (A)
Making (A)
Breaking (A)
12
10
100
10
12
2.5
2.5
2.5
24
10
100
10
24
2.5
2.5
2.5
48
10
100
10
48
2.5
1.4
1.4
60
10
60
60
2.5
1.1
1.1
120
10
6
60
6
125
2.5
0.55
0.55
240
10
30
3
250
2.5
0.27
0.27
480
300
0.23
0.23
10
15
1.5
2.5
600
10
12
1.2
Contact Data
AC 5 Control of AC Electromagnetic Loads
Rated Operational Voltage and Current
Ue (V)
IEC Utilization Categories
Contact Characteristics NC: slow make, double break (positive opening)
Contact Resistance
Contact Fidelity
Logic Reed Contact Data
(Special Order)
le
DC1 3 Control of DC Electromagnets
Rated Operational Voltage and Current
UE (M)
LE (A)122.5
NO: slow make, double break
Self-cleaning (wiping action) contact
Double-bridge contacts with four points of contact
<25mOhm per IEC 255.7 category 3 @ 24V, 1 amp
Minimum current: 5mA
Minimum voltage: 12 Vac/dc. maximum resistance - 2 ohms
NC: Single break
NO: Single break
120 Vac maximum, 0.1 5A maximum, 8VA maximum
30 Vdc maximum, 15A maximum, 4.5W maximum
12
10
24
2.5
24
10
48
10
48
1.4
22MM (N5) OILTIGHT PILOT DEVICES
TECHNICAL DATA
60
10
60
10
1106220
110
0.55
220
0.27
380
3
2
300
0.2
500
1.5
600
1.2
G
23
Mounting
Acceptable Panel Thickness .040 - .236 inches (1-6 mm)
Operator Locking Ring Torque 26 in/lb (3 N -m)
Force Required fo Forcibly Remove
Contact Blocks and Flange
Mounting Dimensions
Mechanical Life Ratings for Opera-
tors
Contact block or power supply from ange: 27 lbs (118N)
3- or 5-block ange from metal operator: 88 lbs (392 N)
3- or 5-block ange from plastic operator: 66 lbs (294 N)
Operators Number of Operations
Standard Push Buttons
Illuminated Push Buttons¹
Momentary Mushroom-head Push Buttons
Maintained Mushroom-head Push Buttons
Push-to-Latch, Turn-to-Release Mushroom-Head Push
Buttons
3-Position Mushroom-head Push Buttons
Non-Illuminated Selector Switches
Illuminated Selector Switches
Joysticks
Toggle Switches
Wobble Sticks
Key-Operated Push Buttons
Selector Push Buttons
3,000,000
1,000,000 - 3,000,000
3,000,000
500,000
300,000
300,000
1,000,000
500,000
500,000
500,000
1,000,000
500,000
1,000,000
¹ Number of operations dependent on the operating duration of the lamp. If the lamp is left on for long periods of time, its heat can reduce
mechanical life. All illuminated push buttons meet at least 1,000,000 operations.
G23
Loading...