Sprayon FG 438-5162-3 User Manual

Safety Data Sheet

Issue date 09-Apr-2015

1. Identification of the Substance/Preparation and of the Company/Undertaking

Product Identifier
Product name
Chemical name

Other means of identification
Product code
Synonyms

Recommended use of the chemical and restrictions on use
Recommended Use
Uses advised against

Details of the supplier of the safety data sheet
Supplier Address

Chase Products Co.
2727 Gardner Road
Broadview, IL 60155
708-273-1121

Emergency Telephone Number
Company Phone Number
24 Hour Emergency Phone Number
Emergency telephone

CHAMPION'S CHOICE SILICONE MOLD RELEASE SPRAY
7-7784

FG 438-5162-3
Mold releaser

To reduce friction and buildup on molds.
See directions for use on product's label.

708-865-1000
1-800-255-3924
ChemTel 1-800-255-3924

2. Hazards Identification

Version 1

Manufacturer Address

Chase Products Co.
2727 Gardner Road
Broadview, IL 60155
708-273-1121

Classification

Skin corrosion/irritation Category 2
Aspiration toxicity Category 1
FLAMMABLE AEROSOLS Category 1
Gases Under Pressure

Label Elements

EMERGENCY OVERVIEW

DANGER

hazard statements

CAUSES SKIN IRRITATION
May be fatal if swallowed and enters airways
EXTREMELY FLAMMABLE AEROSOL
Contains gas under pressure; may explode if heated

liquefied gas

Appearance Clear liquid that will be Physical State Aerosol

_____________________________________________________________________________________________

Page 1 / 8

FG 438-5162-3 CHAMPION'S CHOICE SILICONE MOLD RELEASE SPRAY

_____________________________________________________________________________________________

aerosolized.

Precautionary Statements - Prevention

Wash face, hands and any exposed skin thoroughly after handling
Wear protective gloves, protective clothing, eye protection and face protection.

Keep away from heat, sparks, open flames and hot surfaces. — No smoking

Pressurized container: Do not pierce or burn, even after use
Do not spray on an open flame or other ignition source

Precautionary Statements - Response

Specific treatment: See additional cautionary statements on this label.
IF ON SKIN: Wash with plenty of soap and water
If skin irritation occurs: Get medical advice/attention
Take off contaminated clothing and wash before reuse
IF SWALLOWED: Immediately call a POISON CENTER or doctor.
Do NOT induce vomiting

Precautionary Statements - Storage

Store locked up
Protect from sunlight. Store in a well-ventilated place
Do not expose to temperatures exceeding 50°C (122 °F)

Precautionary Statements - Disposal

Dispose of contents/container to an approved waste disposal plant

Hazards not otherwise classified (HNOC)
Other Information

• Toxic to aquatic life with long lasting effects

0% of the mixture consists of ingredient(s) of unknown toxicity

Odor Petroleum hydrocarbon odor.

Synonyms
Chemical Family
Formula

Chemical name CAS No weight-% Trade secret

n-butane 106-97-8 55-60 *

Propane 74-98-6 20-25 *
Heptane 142-82-5 15-20 *

* The exact percentage (concentration) of composition has been withheld as a trade secret.

FIRST AID MEASURES
Eye Contact

Skin contact

inhalation

3. Composition/information on Ingredients

Mold releaser.
MIXTURES.
7-7784

4. First aid measures

Hold eye open and rinse slowly and gently with water for 15-20 minutes. Remove contact
lenses, if present, after the first 5 minutes, then continue rinsing eye. Call a poison control
center or doctor for treatment advice.

In case of contact, immediately flush skin with plenty of water. Wash skin with soap and
water. If irritation develops, consult a physician.

If overcome by vapor, move person to fresh air. If person is not breathing, call 911 or an
ambulance, then provide artifical respiration, preferably mouth-to-mouth, if possible. Call a
poison control center or doctor for further treatment advise.

INGESTION

Ingestion from an aerosol product is unlikely to occur. Contains petroleum distillates.
Harmful if swallowed. If accidentally swallowed, do not induce vomiting, call physician
immediately.

_____________________________________________________________________________________________

Page 2 / 8

FG 438-5162-3 CHAMPION'S CHOICE SILICONE MOLD RELEASE SPRAY

_____________________________________________________________________________________________

Most important symptoms and effects, both acute and delayed
Symptoms

Indication of any immediate medical attention and special treatment needed
Note to physicians

Acute: Prolonged inhalation of concentrated vapor or mist may cause headaches, dizziness
and nausea. Prolonged and repeated contact with skin may cause irritation and reddening.
Contact with eyes causes irritation.

Contains petroleum distillates, do not induce vomiting because of aspiration neumonia
hazard.

5. Fire-fighting measures

Suitable extinguishing media

Dry chemical, CO2 or water spray.

Unsuitable extinguishing media

Specific hazards arising from the chemical

This product is under pressure. Water spray may be used to cool cans in the vicinity of fire or excessive heat to prevent the
explosion of the cans.

Hazardous combustion products
Explosion data

Sensitivity to Mechanical Impact
Sensitivity to Static Discharge

Protective equipment and precautions for firefighters

As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) and full
protective gear.

Caution: Use of water spray when fighting fire may be inefficient.

Thermal decomposition may release carbon monoxide and carbon dioxide.

Contents under pressure, keep away from heat and open flame.
Keep away from heat, sparks, flame, and other sources of ignition (i.e., pilot lights, electric
motors and static electricity).

6. Accidental release measures

Personal precautions, protective equipment and emergency procedures
Personal precautions
For emergency responders
Environmental Precautions
Environmental Precautions
Methods and material for containment and cleaning up
Methods for Containment

Methods for cleaning up

Use with adequate general or local exhaust ventilation.
Remove all sources of ignition.

See Section 12 for additional Ecological Information.

Provide adequate ventilation to area being treated. Soak up spills with chemically inert,
absorbent material.

Clean contaminated surface thoroughly.

7. Handling and Storage

Precautions for safe handling
Advice on safe handling

Conditions for safe storage, including any incompatibilities

Do not deliberately inhale vapor or spray mist. Avoid getting spray into eyes. Keep out of
reach of children.

_____________________________________________________________________________________________

Page 3 / 8