Spot-on SRL300G, SRL300R Operating Instructions Manual

SRL300R/G Spot-On Rotary Laser 300 Red/Green

Operating Instructions

Self-levelling Automatic Horizontal and Vertical Rotary Laser

1

Maintenance and Safety

• While the instrument is operating, be careful not to expose your eyes to the laser beam. Direct
exposure to a laser beam for a long time may be hazardous to your eyes. The laser beam is
equivalent to a class II .

• Operate this laser so that the laser beam plane avoids impact on the eyes of vehicle drivers or
pedestrians.

• Do not try to dismantle the instrument. Have it repaired by your dealer or supplier. Dismantling yourself
may worsen the problem or void your warranty.

• When attaching the instrument to a tripod, make sure the instrument is securely fixed. The tripod leg
clamps should be securely fastened. If not securely fastened or tightened, the main unit could fall off
or the tripod could fall over.

• The laser should not be stored or used in extreme temperature or during rapid temperature change.
The laser may not function properly if used out of the ambient temperature range.

• Store inside the carry case and place in a dry area not subject to vibration, dust or high moisture.

• If the storage temperature and ambient temperature for usage vary significantly, leave the laser in its

case until it can adjust to the ambient temperature.

• The laser should be transported or carried carefully to avoid impact or vibration.

• The laser should be stored in the carry case and packed with cushioning material. Always handle the

laser with care.

2

1.What is included with your SRL300R

3

Your SRL300R set includes the following parts:-

Rotary Laser (SRL300R)
Receiver (FRD300) and Staff Clamp
Remote Control (FRR200)
Charger (FC100-UK)
Magnetic Laser Target (Red)
Laser Enhancemant Glasses (Red)
Hard CarryCase with Foam Insert

Please contact your supplier if any of the above parts are missing.

4

2. Find your way around the HV/HVG

Handle

Optical Glass

Light House

Control Panel

Base

Rotating Head

Plumb Up Beam

5

2.1 Control Panel

Switch ON/OFF

Left Spin

Right Spin

Direction Scan

H.I Alert

Head Speed

6

2.2 Utilities of Panel

(1) Switch ON/OFF: Powers the laser up or down.

(2) Power indicator: When the light is on, the instrument is on.

(3) Head speed indicator: Indicated the current rotational speed of the unit buy the speed that the LED flashes.

(4)Head speed: Press this button to cycle through the various rotational speeds from 0 - 600rpm.

(5) Tilt/H.I alert: Enabling this mode warns the user if the laser level has been jolted.

(6) Tilt indicator: When the light is blinking slowly, the laser is in H.I alert mode. When the light is blinking
quickly, the laser level will not level as it has been jolted.

(7) Directional scanning: Circling knob. Angle of scanning includes 5 levels: 0-10°-45° -90°-180°

(8) Left-spinning: Used when is scan mode to rotate the lasers head counterclockwise.

(9) Right-spinning: Used when is scan mode to rotate the lasers head clockwise.