Sportspower TR - QL 120 Assembly Instructions
SPORTSPOWER – TRAMPOLINE AND ENCLOSURE
QUICK SET UP GUIDE
PARTS / ADVICE TEL: +44 (0) 1702 208117
Read and follow the complete Instruction Manual or your trampoline can become
misshapen or damaged during assembly. Keep the Instruction Manual.
Trampoline must be assembled and used on a flat, grass covered surface with
minimum clearance all around the frame of 2m (6ft) and 8m (26ft) above the jump
mat.
Two people required for assembly. It is advised to wear gloves and protective
goggles.
The Trampoline and enclosure should not be used until full assembly has been
completed with enclosure in place.
1
Trampoline
Mat
Trampoline
Mat
13
25
37 7 19
31
43
1
Trampoline
Mat
1
37
13
25
8FT TRAMPOLINE
Trampoline
Mat
Trampoline
Mat
15
29
43
8
22
36
50
1
Trampoline
Mat
43
15
29
1
10FT TRAMPOLINE
12FT / 14FT TRAMPOLINE
Trampoline
Mat
19
37
55
10
28
46
64
1
Trampoline
Mat
55
19
37
1
Trampoline
Mat
37
19
55
28
10
46
64 5 14
23
32
41
50
59
68
1
Set out all frame sections in a circle on the ground. Make sure spring holes in top
rail (part 4) are facing upwards. All screws and bolts in frame and legs must be
tightened before spring and mat assembly.
Jump Mat and Spring Assembly
1) It is very important to assemble springs in the correct order otherwise
frame can become misshapen.
2) Make sure Jump Mat side with warning labels is facing upwards.
3) Consider frame to be like a “clock face”.
4) Springs must be installed on opposite sides of the mat / frame in an
alternating manner at equal intervals so that tension is evenly distributed.
2
Loading...