Sportsliter Solutions Tennis System User Manual

See warnings on carton

Installation Instructions

WARNING!

Disconnect power before installation or
servicing. Install, operate and maintain to meet
all applicable codes. Labeled ballast voltage
must match supply voltage. Protect all wiring
connections with approved insulators (by
others). Supply wire temperature rating must
comply with that on label affixed to fixture.
Insure that all internal wiring, excluding
lead wires from reflector assembly, does not
contract reflector assembly or ballast due to high
temperatures. Insure that all retaining hardware is
securely tightened.

SLTC TENNIS SYSTEM

SYSTEM, ARMS AND BRACKETS INSTALLATION

A

Pre-Installation

1. Remove lens door and set aside. To remove lens door, only loosen the retaining
screwing, hinge door open and disengage from hinge brackets at ends of door.

2. Remove lamp (if supplied) from reflector compartment and set aside.

3. Remove ballast compartment barrier by only loosening the retaining screws.

4. Verify the fixture wiring (including PCR if provided) matches the supply voltage.
When multi-tap ballast is supplied, the fixture is wired to the highest voltage.

5. Verify reflector orientation.

The reflector assembly is fully rotatable 360° by 90° increments.

Installation

1. Guide the electrical supply wires from the pole/structure through the mounting
accessory and into the fixture during installation.

2. Install mounting accessory and fixture per installation instructions supplied

with the accessory.

3. If this fixture requires a removable power panel, see the instructions supplied with
the power panel.

4. Make wiring connections

Final Assembly

1. Re-install the ballast compartment barrier.

2. Install proper lamp.

3. Re-install lens door.

SLTC Series Arms and Brackets

B

C

E

G

I

K

268-1227-9901

D

F

H

J

L

WARNING!

Due to a danger of damaging supply wires, any holes drilled into these poles,
arms, or mounting brackets must be drilled BEFORE supply wire is pulled.

Single Arm Assembly (Not requiring SLTC mounting bracket)

1. Place arm tenon (A) into pole top (L) and loosely install three set screws (I).

2. Install fixture on arm (refer to instruction sheet supplied with fixture).

3. Rotate fixture to proper final alignment on pole and alternately tighten set
screws to center arm in pole.

4. Using holes in pole as a guide, drill two 9/16” diameter holes through arm
tenon at locations (J).

5. Install 1/2” bolt (K), lock washer, and nut at location (J).

6. Securely tighten all hardware.

Due to our continued efforts to improve our products, specifications are subject to change without notice.

Copyright © 2013 Hubbell Lighting All Rights Reserved.

For more information visit our web site: http://www.sportslighting.com

Dual and Quad Arm Assembly

1. Place mounting bracket tenon (D) into pole top (L) and loosely install
three set screws (I).

2. Place arm tenons (A) into mounting bracket, align holes and install
thoughbolts (C) and set screws (B).

3. Install fixtures on arms (refer to instruction sheet provided with fixtures).

4. Rotate mounting bracket and fixtures to proper final alignment on pole and
tighten set screws to center mounting bracket in pole.

5. Using holes in pole as a guide, drill two 9/16” diameter holes through mounting
bracket at locations (J).

6. Install 1/2” bolt (K), lock washer, and nut at location (J).

7. Securely tighten all hardware. Note: Setscrews (B) are for fixture leveling only.

8. Wrap shroud (E) around fitter bracket and bend tabs (H) through
slots (G) to secure.

9. Bend tabs (F) down on top of mounting bracket top plate.

SLS0022 SLTC Instruction-A 1/14

Drawing Number: 268-1305-9901