SportsArt Fitness “No Start” 8007 Troubleshooting Manual

SportsArt - 8007 Elliptical Trainer - “No Start” Troubleshooting Guide

1

Table of Contents

Introduction to 8007 Electronic Components - 1
Key Start Troubleshooting Flow Chart 1 – 2
Active Start Troubleshooting Flow Chart 2 – 3
No Active Start - Generator/Sensor Test – 4
No Active Start - Drive/Display Test – 5
No Active Start - Sensor/Drive Test – 6
No Key Start - Drive/Display Test - 7

SportsArt - 8007 Elliptical Trainer - “No Start” Troubleshooting Guide

2

Introduction to 8007 Electronic Components

Battery

Generator

Magnet and

Drive Board

Flywheel

Optic Sensor

1

SportsArt - 8007 Elliptical Trainer - “No Start” Troubleshooting Guide

3

Key Start Troubleshooting Flow Chart

START

Place probes on battery terminals. Without

moving the pedals or arm bars, press the

display panel ON key. Does the meter show

5.2V or more?

Yes

Without moving the pedals

or arm bars, release the

ON key. Does the display

remain lit 2 minutes before

turning off?

No

Does the display turn

off immediately?

Yes

No

Recharge the battery: Adjust LEVEL to
lowest position; Run at 50-60 rates per
minute for half an hour. Or replace the
battery.

If the display doesn't black out
immediately but turns off in less

No

than two minutes, replace the
drive board (capacitor EC9
220U/16V).

See page 7 to determine

Yes

Normal

END

whether issue is in the
display board or drive board.

2