SportsArt Fitness A915 Owner's Manual

INDEPENDENT

CHEST PRESS

INDEPENDENT

CHEST PRESS

A915

OWNER'S MANUAL

ASSEMBLY INSTRUCTIONS

A. SAFETY INSTRUCTIONS

˙ Read all cautions/warnings and obtain proper instruction on use of the machines

prior to using. Use appropriate positioning and controlled movements.

˙

˙

˙

˙

˙

˙

˙

˙

˙

˙

˙

˙

Assemble and operate the strength on a solid, level surface. Do not use outdoors
or near water.

Never allow children on or near the strength.

Make sure all fasteners are properly tightened for safety. DO NOT use the

strength if the unit is disassembled in any way.

Keep head, limbs, and fingers clear of all moving parts.

If at any time during exercise you feel faint, dizzy or experience pain, stop and

consult you physician.

DO NOT wear loose or dangling clothing while using the equipment. Keep away

from all moving parts.

Use care when mounting and dismounting the unit.

DO NOT use any accessories that aren't specifically recommended by the

manufacturer. These might cause injuries or cause the unit to fall.

Close supervision is necessary when this strength is used by, on, or near

adolescent, invalids, and disabled persons.

Use this strength only for its intended use as described in this manual.

Never operate this strength if it has been damaged in any way. If it is not working
properly, been dropped or damaged, contact your dealer. DO NOT attempt to fix a
broken or jammed machine. Notify floor staff.

Never drop or insert any object into any opening.

1

2

B. Introduction

Badge, front

Right grip

Back cushion

Left grip

Pedal push
rod assembly

Pedal push rod
assembly-right

Pedal push rod
assembly-left

Seat cushion and
seat cushion
adjustment handle

Foot pad

Side frame

Badge, rear

Front cover (A)

Foot pad

Support frame

Front cover (B)

Usage sticker

Rear cover

Cord

Stack fork

Hydraulic shock

1. One side

2. One support frame

3. One pedal push rod assy

4. One pedal push rod

5. One grip

6. Four hex socket head bolts M8 x P1.25 x L30, for the pedal push rod assembly and
pedal pushing rod ( )

7. Four spring washers, M8, for the pedal pushing rod assembly and pedal push rod
( )

8. Four flat washers D17 x d8.3 x t2 for foot rest

9. Two hex socket head bolts, M8 x P1.25 x L20, for the pedal push rod and grip

10. Two wave washer, (WN6203) for the pedal push rod and grip

11. One bearing washer for the grip

12. One washer for the pedal push rod

13. One double-end open wrench,17mm x 23mm

14. One double-end open wrench, 8mm x 17mm

15. One hex key wrench, M6

16. One hex key wrench, M5

17. User's manual

18. One double-end open wrench, 8mm x 10mm

19. One double-end open wrench, 12mm x 15mm

20

frame.

right and left

right and left

. One storage tray

3

C. List of Parts

D. STEP BY STEP INSTRUCTION:

1. Tighten the pedal pushing rod with screws as shown in Fig.1.

2. Tighten the grip with screws as shown in Fig.2.

4

Fig.2

Fig.1