Spirit Fires Lucent Gel Fire Assembly And User Instructions Manual

Rev-7 [10-1-2011]

Lucent Gel Fire

ASSEMBLY AND USER INSTRUCTIONS

For use with Approved Fire Gel

Important

THE LUCENT GEL FIRE IS A DECORATIVE FIRE ONLY AND IS NOT TO

BE USED AS A PRIMARY HEAT SOURCE

ENSURE THAT YOU READ THROUGH THIS INSTRUCTION MANUAL

FULLY BEFORE INSTALLATION AND USE

Order Number ………………………………

Please quote this order number when making a warranty claim. Your Warranty
is valid for 1 Year from date of delivery.

Spirit Fires Limited. 4 Beaumont Square, Aycliffe Industrial Park, Newton Aycliffe,

County Durham, DL5 6XN.

Page 2 of 8

ASSEMBLY AND USER INSTRUCTIONS

UNPACKING THE APPLIANCE

Carefully examine the carton for damage before unpacking. If it is obviously
damaged, consult the supplier over whether to proceed.

Make sure the carton is stood upright and open the top. Remove the
cardboard, and place to one side; this can be used as a floor protector when
assembling the fire.

Remove the fire and examine its general condition, paying particular attention
to the fascia, and the stainless steel inglenook.

If satisfied by the general condition, place the decorative components to one
side and proceed with the installation. If in any doubt, seek advice from the
supplier. Read the instructions fully before proceeding.

Page 3 of 8

GENERAL REQUIREMENTS

• The installation must also be in accordance with the relevant parts of local
and national building regulations.

• Soft furnishings, decorations and wall coverings etc. must not be placed
within 1.5 metres of the appliance and its outlets.

• Be aware of curtains etc. that could be blown towards the appliance.

• The fire is intended as a secondary heat source and should not be

used as a primary heat source. Check that a primary heat source
(such as radiators) is present in the room. If insufficient primary heat is
being used there may be a build up of condensation.

• The fire must not be used in rooms where the atmosphere is likely to
contain water or chemical vapours that may adversely affect the
appliance or its finish.

• Do not use while painting or decorating, or in newly decorated rooms as
the residue can lead to unpleasant smells from the appliance. Always
cover or have the appliance removed while decorating.

• This appliance does not contain Asbestos.

• The fire is designed to be wall mounted and must not be recessed into a

fireplace opening.

• The appliance has been designed to be installed onto a wall. It must be
placed on a non-combustible surface of minimum 12mm thickness. The
surface on which the appliance is to be mounted must be flat, level and
square to the back panel. Care should be taken with all wall coverings as
it may discolour them in time.

• The fascia supplied with the appliance must be used.

• The fire must be used in a room with adequate ventilation. It may be

required to open a window when using the appliance.