Spin Master Toys Far East 44647RX2G4, 44647TX2G4 User Manual

For in-depth video instructions go to

AIRHOGS.COM/STUNTSHOT

®

For TROUBLESHOOTING questions and solutions, please visit our website: AIRHOGS.COM/STUNTSHOT

NOTE:

If normal function of the product is disturbed or interrupted, strong electromagnetic interference may be causing the issue. To reset product, turn it completely off, then turn it back on. If normal operation

does not resume, move the product to another location and try again. To ensure normal performance, change the batteries, as low batteries may not allow full function.

SAFETY PRECAUTIONS: -

recommended for the play. - Keep your toy in your sight so that you can supervise it all the time. - New alkaline batteries are recommended for use in controller to obtain maximum performance. - Users should keep
strict accordance with the instruction manual while operating the product.- Your controller/charger is tailor-made for the LiFeP04 rechargeable battery used in your vehicle. Do not use it to charge any battery other
than that in the toy. Note: Parental guidance is recommended when installing or replacing batteries. Under the environment with electrostatic discharge, the toy may malfunction and require user to reset the toy.

SPECIAL NOTE TO ADULTS:

not intended for children under 3 years old. This toy must only be used with the recommended charger.

electronic equipment”. You can return an old product to your retailer when you buy a similar new one. For other options, please contact your local council.

PRODUCT BATTERY REMOVAL INSTRUCTIONS:

Internal battery is factory installed and non-replaceable. Product disassembly and battery removal must be performed by an adult. Do not puncture, cut, tear, compress or deform product during disassembly.
Ensure product is turned off, then use a screw driver to remove screw. Lift end of battery compartment and slide out battery. Dispose of battery in accordance with your local battery recycling or disposal laws.

NOTE:

Opening of product will render product inoperative and voids manufacturer warranties. Dispose of remaining product components in accordance with local laws.

THIS TOY IS EQUIPPED WITH A LITHIUM-ION BATTERY.
SPECIAL LiFe BATTERY INSTRUCTIONS:

exploding, overheating, or igniting. - Do not disassemble, modify, heat, or short-circuit the batteries. Do not place them in fires or leave them in hot places. - Do not drop or subject to strong impacts. - Do not allow
the batteries to get wet. - Only charge the batteries with the specified Spin Master™ battery charger. - Only use the batteries in the device specified by Spin Master™. - Carefully read the instruction guide and use
the batteries correctly. - In the unlikely event of leakage or explosion use sand or a chemical fire extinguisher for the battery. - Batteries must be recycled or disposed of properly.

CARE AND MAINTENANCE:

Do not submerge the toy in water. This can damage the electronic assemblies.

BATTERY SAFETY INFORMATION:

Promptly remove dead batteries from the toy. Dispose of used batteries properly. Remove batteries for prolonged storage. Only batteries of the same or equivalent type as recommended are to be used. DO NOT
incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (i.e. alkaline/standard/rechargeable). Using rechargeable
batteries is not recommended due to possible reduced performance. Rechargeable batteries are only to be charged under adult supervision. Replaceable-rechargeable batteries are to be removed from the toy
before being charged. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.

Keep hands, hair and loose clothing away from the motor/ wheels when power switch is turned ON. - Remove battery(s) from controller when not in use. - Parental guidance is

Regularly examine for damage to the plug, enclosure and other parts. In the event of any damage, the toy must not be used with the charger until the damage has been repaired. This toy is

CONTAINS 1 X 3.2V 500maH LiFe BATTERY PACK AND REQUIRES 2 x 1.5V AAA (LR03) BATTERIES (not Included).

Batteries or battery packs must be recycled or disposed of properly. When this product has reached the end of its useful life, it should not be disposed of with other household waste. The
Waste Electrical and Electronic Equipment Regulations require it to be separately collected so that it can be treated using the best available recovery and recycling techniques. This will
minimize the impact on the environment and human health from soil and water contamination by any hazardous substances, decrease the resources required to make new products and avoid
using up landfill space. Please do your part by keeping this product out of the municipal waste stream! The “wheelie bin” symbol means that it should be collected as “waste electrical and

Never charge battery unattended. - Charge battery in an isolated area. Keep away from flammable materials. - Do not expose to direct sunlight. There is a risk of the batteries

Always remove batteries from the toy when it is not being used for a long period of time (controller only). Wipe the toy gently with a clean damp cloth. Keep the toy away from direct heat.

Requires 2 x 1.5 V AAA (LR03) batteries. Batteries are small objects. Replacement of batteries must be done by adults. Follow the polarity (+/-) diagram in the battery compartment.

Uniquely designed with

lightweight technology

to enable high performance

indoors that won’t damage

your walls or furniture!

CHARGING PORT

POWER SWITCH

ASSEMBLY

FRONT

FRONT

FCC STATEMENT:

interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for Class B digital devices pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference to radio communications. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this toy does cause
interference to radio or television reception (you can check this by turning the toy off and on while listening for the interference), one or more of the following measures may be useful:

• Reorient or relocate the receiving antenna. • Increase the separation between the toy and the radio or the TV.

• Consult the dealer or an experienced TV-radio technician for help. • Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.

NOTE:

and/or 95 and must be expressly approved by Spin Master Ltd or they could void the user’s authority to operate the equipment. Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville, NY

14221. To contact the responsible party please visit fcc.spinmaster.com

--------------------------------------------------------------------------------------------------------------------

Rating: 3.2V 500mAh
Battery: 1 x 3.2V 500mAh LiFe
Rechargeable Battery Pack
Requires: 1 x 3.2V 500mAh LiFe
Rechargeable Battery Pack

Battery requirement for controller

Rating: DC 3 V, 0.45 W
Batteries: 2 x 1.5 V AAA (LR03)
Requires 2 x 1.5 V AAA size batteries

(not included)

Frequency Band(s): 2.420 - 2.465 GHz Maximum radio frequency power transmitted: < 10dBm

T44647_0001_20122217_GEN_IS_R4

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any

Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter component (crystal, semiconductor, etc) could result in a violation of FCC rules under part 15

Battery requirement for toy
Power Supply:

Power Supply:

Spin Master International B.V. hereby declares that the radio
equipment type Stunt Shot™ is in compliance with Directive
2014/53/EU. The full text of the EU declaration of conformity is
available at the following internet address:
http://doc.spinmaster.com

• Do not change or modify anything on the toy.

BEFORE FIRST USE: Read the user's information together with your child.

SPIN MASTER LTD., 225 KING STREET WEST, TORONTO, ON M5V 3M2 CANADA

Imported into EU by SPIN MASTER INTERNATIONAL, B.V., Kingsfordweg 151, 1043 GR Amsterdam, The Netherlands
Imported by Spin Master Australia Pty Ltd, Suite 101, Level 1, 18-24 Chandos Street, St Leonards, NSW 2065;
Spin Master logo & © Spin Master Ltd. All rights reserved. Retain this information, addresses and phone numbers for future reference. Content may vary from
pictures. Keep away from obstacles and electrical hazards.
Spin Master Ltd. reserves the right to discontinue the www.airhogs.com/stuntshot website at any time.

MADE IN CHINA

-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------

a WARNING: CHOKING HAZARD – Small parts.

Not for children under 3 years.



1800 316 982

1 2 3 4

For in-depth video instructions go to

AIRHOGS.COM/STUNTSHOT

CONTENTS

1 x Stunt Shot™

1 x USB
Charging Cable

1 x Controller 1 x Sticker

Sheet

INDOOR

NORTH AMERICA – 1-800 -622-8339
[e-mail]

!

CAUTION:

HAIR ENTANGLEMENT

—
Tie back and cover hair and secure
loose clothing prior to play.

UK – 0800 206 1191, [e-mail]
IREL AND – 180 0 992 249
AUSTRALIA –1800 316 982, [e-mail]

WWW.SPINMASTER.COM

14

2

Not Included

x

AAA

(

LR03

1 x Instruction Guide

5+

)

1.5 V

YRS

HOW TO INSTALL BATTERIES

HOW TO DRIVE

1

1. Open the battery door with a screwdriver
(A). If used batteries are present, remove
these batteries from the unit by pulling up on
one end of each battery. DO NOT remove or
install batteries using sharp or metal tools.

2 3

2. Install new batteries as shown in the
polarity diagram (+/-) inside the battery
compartment.

3. Replace battery door securely. Check your

local laws and regulations for correct recycling
and/or battery disposal.

HOW TO CHARGE

1 2 3

HOW TO FRONT WHEELIE

1

2

1. Turn the vehicle off. 2. Plug the small end of the charging cable

into the charging port.

4

4. Charging LED indicates charging. Blinking for
charging and solid ON when fully charged.

HOW TO CONNECT CONTROLLER

1 2 3

2

3. Plug the charging cable into a 5V DC
computer outlet.

NOTE: LED charging
indicator light is inside of
the chassis. Look through
the cooling vents to see it.

1. Accelerate forwards for 2 seconds.

2. Push the throttle backwards to pop a front wheelie

HOW TO FIX DRIFTING

1. Turn on the vehicle and place it on a flat
surface.

2. Hold the controller near your truck, press

the power button and wait until power
light stops flashing.

3. You are ready to drive.

4. Use the remote control to drive.

CONTROLLER NOT CONNECTING

NOTE: If your truck does not connect to the controller the first time, turn the truck off, turn the controller off and repeat
the HOW TO CONNECT CONTROLLER instructions.

2

3