Page 1
CHOKING HAZARD
WARNING:
Not for Children under 3 years.
Small parts.
®
I O
I
O
CHG
I
O
CHG
I
O
CHG
FINN MCMISSILE
ZERO GRAVITY
INSTRUCTIONS
Off/On/CHG
Switch
®
Forward/
Reverse
Trim
Buttons
5
+
Left/Right
YEARS
Climb
Walls
Button
SAFETY TIPS:
• Drive Finn McMissile Zero Gravity
smooth, clean, flat surfaces only.
• Always turn your controller/charger OFF
before picking up Finn McMissile Zero Gravity®.
• Keep fingers, hair and loose clothing away
from wheels and tires while Finn McMissile
Zero Gravity®is turned ON.
• Always make sure Finn McMissile
Zero Gravity®and his controller/charger are
turned OFF when not in use.
Contents: • 1 x Finn McMissile Zero Gravity®Vehicle
• 1 x Controller/Charger • 1 x Instruction Guide
®
on
Finn McMissile
Zero Gravity
INSTALLING/REPLACING THE BATTERIES
1. Open the battery door with a screwdriver (not included).
2. If used batteries are present, remove these batteries from the
unit by pulling up on one end of each battery.
3. Install new batteries as shown in the polarity diagram (+/-)
Battery
Compartment
Door
6
1.5V
Alkaline
Batteries
Battery
Compartment
• Controller requires 6 x 1.5V AA alkaline
batteries (not included).
• Batteries are small objects.
• Replacement of batteries must be done
by adults.
• Follow the polarity (+/-) diagram in the
battery compartment.
• Promptly remove dead batteries from
controller.
• Dispose of used batteries properly.
• Remove batteries for prolonged storage.
• Only batteries of the same or equivalent
type as recommended are to be used.
• DO NOT incinerate used batteries.
Controller/Charger
®
inside the battery compartment.
4. Replace battery door securely.
5. Check your local laws and regulations for correct recycling
and/or battery disposal.
BATTERY SAFETY INFORMATION
• DO NOT dispose of batteries in fire, as
batteries may explode or leak.
• DO NOT mix old and new batteries.
• DO NOT mix different types of batteries,
i.e.: alkaline/standard (carbon-zinc) or
rechargeable batteries.
• DO NOT use rechargeable batteries.
• DO NOT recharge non-rechargeable
batteries.
• DO NOT short-circuit the supply
terminals.
• DO NOT store your vehicle or controller
near heat or in direct sunlight.
CHARGING FINN MCMISSILE ZERO GRAVITY
1. Turn vehicle OFF.
5. Slide switch on controller/
charger to CHG.
2. Turn controller/charger
OFF.
6. The red charging light will
begin to flash. When charging is
complete the light will turn OFF.
®
3. Open charge door
to access charge
cable.
7. When charging is complete,
turn controller/charger
switch OFF.
4. Plug the charge plug into
the charge port in the back of
the vehicle.
8. Store charge
cable in storage
compartment.
Page 2
PLAYING WITH FINN MCMISSILE ZERO GRAVITY
1.2
metres
I
O
CHG
I O
I
O
CHG
I O
L
R
®
1. Stand at least 1.2 metres
from the wall. The floor to wall
transition must be at right
angles with no obstructions
such as baseboards.
If your house
has baseboards,
try using
furniture that
is flush to the
ground or see
instructions
below.
Vehicle Features:
Finn McMissile Zero
®
Gravity
features a
suction throttle,
plastic air skirts and
driving wheels that
allow him to perform
full RC functions
while traveling on
walls.
The fabric air skirts can be adjusted to
ensure proper vehicle air suction to the wall.
2. Only drive on smooth, clean,
dry empty surfaces (no hanging
pictures or other obstacles). Do not
drive on uneven, porous, or broken
surfaces, as vehicle will not adhere
and can fall off. Avoid
driving above fragile
objects and do not
stand beneath
vehicle when
driving overhead.
Driving
Wheels
to ensure proper
3. DO NOT drive over wall
sockets, light switches
or other obstructions.
DO NOT drive
close to
or off the
edge
of the
wall.
Adjusted
air skirt at 45°
wall suction.
WARNING:
Finn McMissile
Zero Gravity®will
not transition from
wall to ceiling.
Attempting to do
this will cause the
vehicle to fall
which could lead
to damage or
personal injury.
Secondary
wheels
featured on
the front and
rear of the
vehicle help
the vehicle
transition
from a level
surface to a
wall.
IMPORTANT: Your Finn McMissile Zero Gravity
Turn vehicle ON.
Turn controller/charger ON.
Power LED will turn on.
TRIM ADJUSTMENT
1. If the vehicle turns to the LEFT,
press the right trim button until it
drives straight.
Trim Adjustment
Buttons
NOTE: Do not drive higher than 1.8 metres from the ground.
GETTING STARTED – DRIVING ON THE GROUND
®
Dirt or debris can get inside the fan and cause internal damage.
Forward/
Reverse
The LEFT stick
controls the vehicle’s
forward and
reverse driving.
2. If the vehicle turns to the Right,
press the left trim button until it
drives straight.
should be driven only on smooth, clean, flat surfaces.
Left/Right
The RIGHT stick controls the
vehicle’s steering left and right.
When finished playing, be sure to turn the
controller and vehicle OFF!
Turn
vehicle
OFF.
1
Turn controller/charger OFF. Power LED
2
will turn OFF.
Page 3
I O
I
O
CHG
CLIMBING WALLS
I O
I
O
CHG
1. Turn vehicle ON.
4. Place vehicle on floor and use the left forward/reverse
stick to drive towards the wall.
6. If your wall has baseboard
trim, the vehicle may not be able
to make the transition. You may
create a ramp using cardboard
as shown here to transition over
obstacles such as baseboards.
7. You may also transition from
a flat surface such as a table
or desk.
67
2. Turn controller/charger
ON. Power LED will turn on.
5. Once the vehicle
is parallel to
the wall, it
will start
to climb.
3. Press the Climb Walls button to turn
the suction air fan ON.
Alternate Start on Walls
Once the air fan is running
you can place the vehicle
directly on the wall instead
of driving it onto the wall.
NOTE: DO NOT turn the
air fan OFF while driving
on the wall as this may
damage Finn McMissile
Zero Gravity
the air fan OFF when
vehicle is on a horizontal
surface.
®
. Only turn
CLIMBING OFF WALLS
1, 2. You can
drive the vehicle
forward or
backwards
towards the
floor.
IMPORTANT: The Finn McMissile Zero Gravity®Wall Climber may not work on windows, glass or reflective surfaces as the remote
function could be impaired.
24
3, 4. Once vehicle reaches
the bottom of the wall it will
transition to the floor and
drive away.
ONCE YOUR FINISHED PLAYING
1. Press the Climb Walls button to turn
the suction air fan OFF.
2. Turn vehicle OFF.
3. Turn controller/charger OFF.
Page 4
Contains LiPo battery pack. • Battery pack must be recycled or disposed of properly.
• If at any time in the future you should need to dispose of this product please note
that Waste Electrical Products should NOT be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or retailer for
recycling advice. (Waste Electrical and Electronic Equipment Directive).
Warning:
Choking Hazard –
Small Parts.
TROUBLESHOOTING GUIDE
PROBLEM CAUSE
Vehicle is slow or will not
move.
Vehicle does not drive in a
straight line.
Vehicle is damp or wet.
My vehicle and/or controller
is dirty.
Vehicle is not responding
or driving on it’s own.
NOTE: If normal function of the product is disturbed or interrupted,
strong electro-magnetic interference may be causing the issue. To
reset product, turn it completely off, then turn it back on. If normal
1. Batteries in the controller
need to be replaced.
2. Vehicle is out of range of
controller.
3. There is hair or debris stuck
in the wheels or wheel axles.
4. Batteries are installed
incorrectly.
5. Improper surface for vehicle.
Vehicle requires wheel
alignment.
Inappropriate driving surface/
conditions.
1. Inappropriate driving surface.
2. Dirty hands.
1. Using another vehicle/controller of the same frequency.
2. Infra-red interference from
another source.
SOLUTION
1. Replace batteries in the controller with new, fresh batteries.
2. Move closer to the vehicle.
3. With the vehicle and controller turned off, have an adult carefully
remove the hair or debris from the wheels or wheel axles.
Remove debris by blowing gently on the fan area located on the
bottom of the vehicle.
4. With the vehicle and controller turned off, have an adult check
that the batteries are installed correctly in the controller.
5. Change your play area to a hard, flat surface. Examples of poor
play surfaces are thick carpet, grass or sand. Examples of good
play surfaces are non-carpeted floors or concrete.
Refer to Trim Adjustment guide on page 2.
Turn the controller off and ask an adult to safely remove the vehicle
from the water source. It’s recommended to discontinue use of the
toy. Once dry, the vehicle should be properly disposed of.
Ensure the controller and vehicle are off. Have an adult remove
the batteries first and replace the battery cover. Slightly dampen
a clean cloth in water and wipe toy clean. Wipe dry. DO NOT
IMMERSE IN WATER and DO NOT USE ANY CHEMICALS.
Let the toy completely dry before putting batteries back into clean,
dry battery compartment.
®
Do not operate Finn McMissile Zero Gravity
around devices that
emit other infra-red signals.
operation does not resume, move the product to another location
and try again. To ensure normal performance, change the batteries,
as low batteries may not allow full function.
This product complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for Class
B digital devices pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference to radio communications. Because this toy
generates, uses, and can radiate radio frequency energy, there can be no guarantee that interference will not occur. If not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. If this toy does cause interference to radio or television reception (you can check this by turning the toy off and on while listening
for the interference), one or more of the following measures may be useful: • Reorient or relocate the receiving antenna • Increase the separation between the toy and the radio or the TV
• Consult the dealer or an experienced TV-radio technician for help. NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter
component (crystal, semiconductor, etc.) could result in a violation of FCC rules under part 15 and/or 95 and must be expressly approved by Spin Master Ltd. or they could void the
user’s authority to operate the equipment.
CANADIAN Class B statement: This class B digital apparatus meets all the requirements of the Canadian Interference-Causing Equipment Regulations.
Your Finn McMissile Zero Gravity®is equipped with a
Lithium Polymer battery.
SPECIAL LIPO BATTERY INSTRUCTIONS:
- Never charge battery unattended.
- Charge battery in isolated area. Keep away from flammable materials.
- Do not expose to direct sunlight.
- There is a risk of the batteries exploding, overheating, or igniting.
Do not disassemble, modify heat, or short-circuit the batteries.
Do not place them in fires or leave them in hot places.
- Do not drop or subject to strong impacts.
- Do not allow the batteries to get wet.
- Only charge the batteries with the specified Spin Master™
battery charger.
- Only use the batteries in the device specified by Spin Master™.
- Carefully read the instruction guide, and use the batteries correctly.
- In the unlikely event of leakage or explosion use sand or a
chemical fire extinguisher for the battery.
- Batteries must be recycled or disposed of properly.
IMPORTANT SAFETY INFORMATION: Keep clear from face, eyes, and hair at all
times. Do not aim at people or animals. Play with this product in a wide-open room, far
away from breakable items. Avoid playing near vents and/or fans, as these may over
power this product and make it difficult to control. NOTE: Always get permission to play
with this product indoors. ADULT SUPERVISION RECOMMENDED.
PRODUCT BATTERY REMOVAL INSTRUCTIONS: Internal battery is factory
installed, product disassembly and battery removal must be performed by an adult.
Do not puncture, cut, tear, compress or deform product during disassembly. Ensure
product is turned off, then use a screw driver to remove all screws. Separate product
body halves to expose internal electronics. When battery is visible in its entirety use
scissors to cut a single battery wire, immediately wrap the cut wire end with tape to
isolate it, repeat until all battery wires are cut and isolated, and the battery is free
from the rest of the product. Dispose of battery in accordance with your local battery
recycling or disposal laws. NOTE: Opening of product and/or removal of battery will
render product inoperative and voids manufacturer warranties, dispose of remaining
product components in accordance with local laws.
SPIN MASTER LTD., 450 FRONT STREET WEST, TORONTO, ON M5V 1B6 CANADA
Customer Care: 1-800-622-8339 Fax: 416-364-8005
Email: customercare@spinmaster.com
Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville,
NY 14221, USA
Spin Master Toys Far East Limited, Rm #1113, 11/F, Chinachem Golden Plaza, 77 Mody Rd.,
Tsimshatsui E., Kowloon, HK
Imported by:
SPIN MASTER INTERNATIONAL, S.A.R.L., 16 AVENUE PASTEUR, L-2310, LUXEMBOURG
www.spinmaster.com
© Disney/Pixar. Air Hogs®, related trademarks & © 2011 Spin Master Ltd.
All rights reserved. This product conforms to safety requirements of ASTM F963,
EN71 & CHPA. • Please retain this information for future reference. • Please remove
all packaging materials before giving to children. • An adult should periodically
check this toy to ensure no damage or hazards exist, if so, remove from use.
• Children should be supervised during play. • Keep addresses and phone numbers
for future reference. • The item inside this package may vary from the photographs
and/or illustrations. MADE IN CHINA.
20039958 GTL English REV 0
T43004_0001_20039958_GTL_IS_R1
TM
Loading...