Spin Master Black Belts User Manual

FILL INSTRUCTIONS
NOTE: ADULT ASSISTANCE REQUIRED
Unfold Heavy Bag and place flat on the floor.
• The Black Belts
TM
TM
2
1
ADD WATER TO LOWER BASE
Locate base filler area and remove the filler cap.
Remove filler plug.
Heavy Bag takes all the kicks and punches that you can dish out and bounces back for more!
3
Add water to base, being careful not to over fill it.
4
Add filler plug.
NOTE: Bag should be inflated to its fullest potential.
5
Reinstall filler cap.
ADD AIR TO UPPER BASE
WARNING:
Locate and open air nozzle on top of base.
Pinch base of nozzle to allow air to enter.
21
ADD AIR TO UPPER PUNCH/KICK BAG
Locate and open air nozzle on upper punch/kick bag.
Pinch base of nozzle to allow air to enter.
Fill top of base with air and then replace the air nozzle cap.
Fill upper kick/punch bag with air and then replace the air nozzle cap.
1
TROUBLESHOOTING
If Heavy Bag will not fill up.
If Heavy Bag falls over and stays down.
If Heavy Bag deflates.
NOTE: Weight of water should be 12 lbs.
Some segments of the exercise or movements can be strenuous to some individuals. It is important to ensure your child does not have any medical or physical conditions that would cause illness or injury. When in doubt please consult a physician.
• ADULT SUPERVISION REQUIRED. Children should only attempt moves shown in the video within their limitations and capabilities and it is required that any jumps or extreme movements be monitored or assisted.
– Check to ensure that you are pinching the Air Nozzle firmly.You should be able to hear the air inflating the bag and see the bag increase in size as air is added.
– If air is entering bag and Heavy Bag still does not fill up, check to ensure that there is no hole in the bag. This can be checked by immersing the bag in water and seeing if air bubbles are exiting the bag from any point. If so, holes can be repaired by covering them with duct tape.
– Check base of Heavy Bag to ensure that no water is leaking from the bottom. A properly filled Heavy Bag should return upright when punched.
– Check to ensure that there is no hole in the bag. This can be checked by immersing bag in water and seeing if air bubbles are exiting the bag from any point. If so, holes can be repaired by covering them with duct tape.
2
• The mat supplied with the product should be set up on a non-slip surface. Where used on smooth surfaces such as wood or ceramic, a non-slip liner or two sided tape is recommended to be placed beneath the mat.
• The mat should be set up in open spaces free of clutter, far away from walls, tables, chairs, etc. as many of the karate moves involve balance and jumping.
Spin Master Ltd. 450 Front Street West, Toronto, ON M5V 1B6 Canada Phone: 1-800-622-8339 Fax: 416-364-8005 Web: www.spinmaster.com Email: toys@spinmaster.com
© 2004 Spin Master Ltd. TM Black Belt Karate Studio, trademark of Spin Master Ltd. All Rights Reserved. Made in China. Item #51004 REV 4 US English
TM
Loading...