
INSTRUCTIONS
TM
Vertical
Tail Wing
ail Wing
T
Holder
Tail Wing
Rubber Band
Main Wing
Rubber Band
Horizontal
ail Wing
T
Air
Tank
Plane
Body
Air Intake
Main Wing
Nose
Cone
Ages 8 and up
Pump Handle
Propeller
Pump
Nozzle
AIR PUMP
Pump
Shaft
Pump
Base
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE FLYING YOUR AIR HOGS®SKY SHARK
Congratulations! You are the proud owner of original AIR HOGS®the loudest, fastest and furthest flying air
pressure plane ever! The secret behind AIR HOGS
engine, which is built to provide awesome performance and unbeatable flight times.
®
is the revolutionary design of the R.A.I.D. air pressure
ASSEMBLY INSTRUCTIONS
STEP 1
Slide the back part
of the MAIN WING
HARNESS around the
BACK MOUNTING PIN
on the PLANE BODY.
STEP 2
Push down on the
front part of the
WING until it
MAIN
‘CLICKS’.
NOTE:
WING
should now be
secure on the
FRONT
MOUNTING
The MAIN
HARNESS
and BACK
PINS.
Back
Mounting
Pin
Main
ing
W
Main Wing
Harness
STEP 3
Wrap the MAIN
WING RUBBER
BAND around
the AIR TANK
and hook it onto
the MAIN WING
HARNESS TAB.
Main Wing
Harness
Main
ing
W
Plane
Body
Back
Mounting Pin
Plane
Body
Main
W
Air
Rubber
Tank
Band
Main
Wing
Harness
Ta b
ing
TM
STEP 4
Insert TAIL WING
MOUNTING TAB
into the TAIL
WING SLOT on
the rear of the
plane.
Tail Wing
Slot
Main Wing
Mounting Tab
STEP 5
Wrap the TAIL WING
RUBBER BAND around
the tail of the plane, and
hook it onto the TAIL
WING HARNESS TAB.
Horizontal
Tail Wing
Tail Wing
Harness
Ta b
Tail Wing
Rubber
Band

STEP 6
Install the
VERTICAL TAIL
WING by sliding
it into the TAIL
WING HOLDER.
ertical
V
T
W
ail
ing
STEP 7
Apply your AIR HOGS
stickers to the surface
of the MAIN WING and
VERTICAL TAIL WING.
See packaging for
ail
T
ing
W
Holder
placement of stickers.
Make sure your stickers
are on flat, because
creases in the stickers
will affect the flight.
PUMP UP YOUR SKY SHARK™
®
Stickers
STEP 1
Push the plane’s
AIR INTAKE
down onto the
PUMP NOZZLE.
STEP 1
Hold the plane in
your launching
hand and strike
the propeller with
your other hand.
Air
Intake
STEP 2
Pump 50 times
(or until the air
tank is full).The
pressure release
valve will release
air or whistle
STEP 3
Carefully
remove the
plane AIR
INTAKE from
the PUMP
NOZZLE.
when AIR TANK
is full.
Pump
Nozzle
CAUTION: Only use pump supplied with AIR HOGS®Sky SharkTM.
Do not use any other source to pump AIR HOGS®Sky SharkTM.
FLIGHT INSTRUCTIONS
STEP 2
Launch your
Sky Shark
against the
wind for best
take-of
flight results.
TM
45°
f and
Air
Intake
Pump
Nozzle
ail
T
Left
Flap up
Plane
banks left
Gently bend the LEFT TAIL
FLAP up to make the plane
bank to the
left.
NOTE: No change to the
RIGHT TAIL FLAP.
BASIC FLYING TIPS
Right Tail
Flap up
Plane
banks right
Gently bend the RIGHT
up to make the plane
FLAP
bank to the
NOTE: No change to the
LEFT
T
AIL
right.
FLAP
.
T
AIL
Right Tail
Left Tail
Flap up
Flap up
Plane climbs
Gently bend both
HORIZONT
AL
FLAPS
AIL
T
up to make the plane climb
higher/faster.
Left Tail
Flap down
Plane dives
Gently bend both
T
HORIZONT
down to
AL
vent plane fr
pre
crashing/stalling
Flap down
AIL
.
Right Tail
FLAPS
om