
ADULT SUPERVISION IS REQUIRED
INSTRUCTIONS
Contents:
1 Plane
1 Pump, 1 Main Wing
Wing Assembly
1 Rear
Thank you for purchasing the Air Hogs®Blue Sky
The Blue Sky
the Rehco Rocket
Blue Sky
M
T
is a real-flying plane and is powered by a miniature air pressure engine, called
M
T
requires no gas and no batteries... Just Pump It Up!
ertical
V
Tail Wing
Tail Flap
ear Wing
R
arness
H
ain
M
Wing
M
T
. The Blue Sky
orizontal
H
ail Wing
T
ain Wing
M
lignment
ain Wing
M
Alignment
T
ir
A
Tank
ir
A
Intake
M
T
reaches exciting heights of up to 50 feet. Powered by air, the
A
Slot
ab
Pump Base
M
T
and welcome to the exciting world of flight!
Pump
andle
H
Pump
S
Pump
ozzle
N
haft
PUMP UP YOUR BLUE SKY
1. Gently push the PUMP NOZZLE
all the way onto the AIR INTAKE
on the nose of the plane.
2. Push pump 40 times (or until the
AIR TANK is full).
Air
Nozzle
TIP: You will know the AIR TANK is
full when the release valve whistles.
3. Hold the plane by the engine
housing and gently
remove the plane from
the pump.
Use only the AIR PUMP that comes with your
BLUE SKY
unique built-in pressure relief valve to ensure that
TM
airplane. For safety, this pump has a
the AIR TANK is not over filled.
WING RE-ASSEMBLY
TM
ability, it has
o increase the Blue Sky
T
been equipped with pop-off wings
significantly help the plane to a
impact with harsh surf
ANT: While pop-off wings do help to protect
T
IMPOR
the product against damage
o help preserve the life of your Blue Sky
T
fly in a
wide-open area with lots of grass.
s dur
’
Pop-off wings
.
oid breakage on
v
aces (ie. ground, trees etc.)
, they are not foolproof.
TM
TM
, alw
FLIGHT INSTRUCTIONS
1
Starting the motor
Hold the plane in your launching hand
and flick the propeller downward with
your other hand.
2
M
Launch Blue Sky
the wind for best take off and
flight results.
T
against
3
To achieve a level flight you may
have to adjust the right and left
wing flaps up or down.
• Gently bend the Left flap
up to make the plane bank
to the Left.
• Gently bend the Right flap
ys
a
up to make the plane bank
to the Right.
Right Wing Flap
Left Wing
Flap
1
Insert the MAIN WING
ALIGNMENT TAB into
the MAIN WING
ALIGNMENT SLOT.
2
WING
ap the FR
Str
HARNESS o
front of the MAIN
ap the elastic around the
wr
ANK.
T
AIR
ONT
ver the
WING and
3
ap the REAR
Str
WING HARNESS
around the bac
ANK.
T
AIR
k of the
4
Make sure VERTICAL TAIL
WING is straight. Also ensure
HORIZONTAL TAIL WING is
level with MAIN WING.
Vertical
ontal
iz
Hor
Tail Wing
Tail Wing
5
Bend both TAIL
FLAPS up to
e plane
mak
climb higher/
.
aster
f
6
Bend both TAIL
FLAPS do
plane is climbing
shar
ashing.
cr
wn if
ply, then

IMPORTANT SAFETY INFORMATION – ADULT SUPERVISION IS REQUIRED
• Keep propeller clear from face, eyes and fingers. Do not launch at
people or animals.
• Pay attention. Make sure people around you know you are playing with
Blue Sky
pump included in this package. Other pumps may damage the plane or
lead to injury. Never pump anything except air into the engine. Do not
leave air in reservoir.
• Do not leave your Blue SkyTMAIR TANK pressurized in direct sunlight
TM
. Point plane away from face when launching. Use only the
and/or extreme heat for excessive amounts of time.
• Do not fly in very windy conditions. Do not fly plane in temperatures
below 45°F/7°C or the wings will become brittle and may break, and
engine performance will decrease.
• Do not fly near overhead wires, trees, buildings, or other obstructions.
• After your last flight, spin the propeller to make sure all the air has been
used up. Only use your Blue Sky
the propeller, gently touch the nose cone to the grass.
TM
plane in grassy open area. To stop
TROUBLESHOOTING GUIDE
ROBLEM
P
Engine will not start.
TM
Blue Sky
flight path.
Blue Sky
OZZLE.
N
Wings on your Blue SkyTMget damaged.
does not have a level
M
T
AIR INTAKE will not fit into PUMP
• No air in AIR TANK.
• Blue Sky
NOZZLE are clogged with dirt.
• TAIL WING FLAPS not adjusted properly.
• Check for dirt in Blue Sky
NTAKE or PUMP NOZZLE.
I
AUSE
C
TM
AIR INTAKE or PUMP
T
SOLUTION
• Pump up Blue Sky
is horizontal.
• Clean out AIR INTAKE with a toothpick and
re-pump.
• Re-adjust the TAIL WING FLAPS. FLAP UP to
prevent dives and FLAP DOWN to prevent stall.
M
AIR
• Clean out with a toothpick.
• The wings can easily be repaired with clear tape.
TM
and make sure PROPELLER
DISPOSAL INFORMATION
When your Blue Sky™ plane is no longer functional, its components can be disposed of in the following manner:
Air Pressure
Bottle
Foam
Engine
Surround
A Remove 2 screws from
front engine component.
Wing Assembly
Engine
Foam Engine Surround
B Remove 3 screws from
rear engine component.
Remove
Decals
Foam
Packaging Materials
All Blue Sky™ packaging materials and
instruction sheets are readily recyclable
through your local program.
Aircraft Wings and Body
All foam materials are made of polystyrene.
Please dispose along with your regular
solid waste garbage, or in your blue box
if polystyrene recycling facilities exist in
your area.
Air Pressure Bottle
This bottle is made from recyclable PETE.
A. Using a small Phillips head (star)
screwdriver, carefully remove the 2 screws
from the front engine compartment.
B. Remove the front engine compartment
and then remove the 3 screws securing the
bottle to the engine
Detach the bottle and dispose through y
program.
.
our local recycling
All remaining parts: The pump, motor and all remaining parts are non-recyclable. Please dispose of appropriately.
Spin Master Ltd., 450 Front Street West, Toronto, ON M5V 1B6 Canada
Spin Master
Williamsville
Spin Master Toys Far East Limited, Rm #1113, 11/F,
Chinachem Golden Plaza, 77 Mody Rd., Tsimshatsui E., Kowloon, HK
North American Consumer Information
Phone: 1-800-622-8339
www.spinmaster.com
, Inc., PMB #10053, 300 Inter
, NY 14221, USA
national Dr
iv
e, Suite 100,
AIR HOGS ® is a registered trademark and Blue Sky TM
is a trademark of Spin Master Ltd. © 2007 Spin Master Ltd.
ights reser
All r
ASTM F963, EN71 Regulatory Requirements. Please retain
this information for future reference. Please remove all
packaging material before giving to children. Products and
colors ma
#20012429 NEN REV 1
ed. Conforms to product safety standards
v
y vary. MADE IN CHINA.
TM