Spin Master Air Hogs 45130, Air Hogs Sky Shark XRG User Manual

Download

Page 1

INSTRUCTIONS

Vertical

Tail Wing

ail Wing

Holder

Tail Wing

Rubber Band

Main Wing

Rubber Band

Horizontal

ail Wing

Air

Tank

Plane

Body

Air Intake

Main Wing

Nose Cone

Ages 8 and up

Pump Handle

Propeller

Pump

Nozzle

AIR PUMP

Pump

Shaft

Pump

Base

PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE FLYING YOUR AIR HOGS®SKY SHARK

Congratulations! You are the proud owner of original AIR HOGS®the loudest, fastest and furthest flying air pressure plane ever! The secret behind AIR HOGS engine, which is built to provide awesome performance and unbeatable flight times.

is the revolutionary design of the R.A.I.D. air pressure

ASSEMBLY INSTRUCTIONS

STEP 1

Slide the back part of the MAIN WING HARNESS around the BACK MOUNTING PIN on the PLANE BODY.

STEP 2

Push down on the front part of the

WING until it

MAIN ‘CLICKS’. NOTE: WING should now be secure on the FRONT MOUNTING

The MAIN

HARNESS

and BACK

PINS.

Back

Mounting

Main

ing

Main Wing

Harness

STEP 3

Wrap the MAIN WING RUBBER BAND around the AIR TANK and hook it onto the MAIN WING HARNESS TAB.

Main Wing

Harness

Main

ing

Plane

Body

Back

Mounting Pin

Plane

Body

Main W

Air

Rubber

Tank

Band

Main

Wing

Harness

Ta b

ing

STEP 4

Insert TAIL WING MOUNTING TAB into the TAIL WING SLOT on the rear of the plane.

Tail Wing

Slot

Main Wing

Mounting Tab

STEP 5

Wrap the TAIL WING RUBBER BAND around the tail of the plane, and hook it onto the TAIL WING HARNESS TAB.

Horizontal

Tail Wing

Harness

Ta b

Tail Wing

Rubber

Band

Page 2

STEP 6

Install the VERTICAL TAIL WING by sliding it into the TAIL WING HOLDER.

ertical

ail ing

STEP 7

Apply your AIR HOGS stickers to the surface of the MAIN WING and VERTICAL TAIL WING. See packaging for

ail

ing

Holder

placement of stickers. Make sure your stickers are on flat, because creases in the stickers will affect the flight.

PUMP UP YOUR SKY SHARK™

Stickers

STEP 1

Push the plane’s AIR INTAKE down onto the PUMP NOZZLE.

STEP 1

Hold the plane in your launching hand and strike the propeller with your other hand.

Air

Intake

STEP 2

Pump 50 times (or until the air tank is full).The pressure release valve will release air or whistle

STEP 3

Carefully remove the plane AIR INTAKE from the PUMP

NOZZLE. when AIR TANK is full.

Pump

Nozzle

CAUTION: Only use pump supplied with AIR HOGS®Sky SharkTM.

Do not use any other source to pump AIR HOGS®Sky SharkTM.

FLIGHT INSTRUCTIONS

STEP 2

Launch your Sky Shark against the wind for best take-of flight results.

45°

f and

Air

Intake

Pump

Nozzle

ail

Left Flap up

Plane

banks left

Gently bend the LEFT TAIL FLAP up to make the plane bank to the

left.

NOTE: No change to the RIGHT TAIL FLAP.

BASIC FLYING TIPS

Right Tail

Flap up

Plane

banks right

Gently bend the RIGHT

up to make the plane

FLAP bank to the NOTE: No change to the LEFT

AIL

right.

FLAP

AIL

Right Tail

Left Tail Flap up

Flap up

Plane climbs

Gently bend both HORIZONT

FLAPS

AIL

up to make the plane climb higher/faster.

Left Tail

Flap down

Plane dives

Gently bend both

HORIZONT down to

vent plane fr

pre

crashing/stalling

Flap down

AIL

Right Tail

FLAPS

Page 3

REPAIR CENTER

If the wings on your AIR HOGSTMplane get damaged, they can be easily repaired with clear tape.

CLEAR

TAPE

IMPORTANT SAFETY INFORMATION

Keep propeller clear from face, eyes, and fingers. DO NOT launch at people or animals. Use caution; make sure people around you know you are playing with Air Hogs®. Recommended for use in wide-open, grassy area. DO NOT fly near overhead wires, trees, buildings, or other obstructions. Point plane away from face when launching. DO NOT fly in temperatures below 45°F/7°C. In these low temperatures, the wings will become brittle, and engine peformance is severely decreased. DO NOT fly in rain, electrical storms, snow, or other adverse weather conditions. Use only the pump included in this package. Other pumps may damage the plane or lead to injury. Never pump anything except air into the engine. DO NOT leave air in plane. After your last flight, spin the propeller to make sure all the air has been used up.

ADULT SUPERVISION RECOMMENDED.

PROBLEM

Engine with not start.

Sky SharkTMdoes not have a level flight path.

Sky SharkTMAIR INTAKE will not fit into PUMP NOZZLE.

WINGS on your Sky

Shark

are damaged.

CAUSE

1. No air in AIR TANK.

2. Sky Shark

AIR INTAKE or PUMP

NOZZLE is clogged with dirt.

1. HORIZONTAL TAIL FLAPS not adjusted properly.

1. Check for dirt in Sky Shark

AIR INTAKE or PUMP NOZZLE.

1. Pump up Sky Shark

2. Clean out opening with a toothpick and re-pump.

1. Re-adjust HORIZONTAL TAIL FLAPS. Bend TAIL FLAPS up to climb, and bend TAIL FLAPS down to prevent stalling.

1. Clean out AIR INTAKE and PUMP NOZZLE with a toothpick.

1. Repair the WINGS with clear tape.

SOLUTION

WARRANTY (U.S.A.)

Spin Master Ltd. warrants to the original consumer purchaser, that this product is thoroughly tested and inspected before shipment and is guaranteed to be free of factory defects in materials and workmanship for thirty (30) days (unless specified in alternate warranties) from the date of purchase.

In the event of such a defect within the warranty period, Spin Master Ltd., at our sole option, will repair or replace the product or pro vide you with another product of equal value. Repair or replacement shipment is free of charge. Shipping replacement may take 2 to 6 weeks, depending on customer

In the event of a defect covered under this warranty this manner customer an additional handling charge if you send the entire toy.

The warranty is valid if and only if the product has been operated in accordance with the instructions. This warranty does not cover worn or defective batteries, damage resulting from neglect, unauthorized modification, accident, misuse, abuse, any action or omission which constitutes a deviation from the instructions or from the use of accessories or parts not manufactured by Spin Master Ltd. If the product is returned without a dated sales receipt the product is excluded from coverage under this warranty.

Spin Master Ltd.’s liability for defects in material and workmanship under this warranty shall be limited to repair or replacement, at our sole option, and in no event shall we be responsible for accidental, consequential, or contingent damages (except in those states that do not allow this exclusion or limitation) or refunds. This warranty is exclusive, and is made in lieu of any express or implied warranty. This warranty is valid only for products sold in the U.S.A. This warranty gives you specific legal rights and you may have other rights, which vary from state to state. Some states do not allow the exclusion of incidental or consequential damages, so the above exclusions or limitations may not apply to you.

Spin Master Ltd. reserves the right to improve the design of any product without assuming any obligation to modify any product previously manufactured.

SPIN MASTER LTD. CUSTOMER CARE CENTRE 450 Front Street West Toronto, Ontario M5V 1B6 CANADA TOLL-FREE NUMBER 1-800-622-8339 (valid only in North America) Hours: 8:00 A.M. – 5:00 P.M. Eastern Time: Monday – Friday.

. If necessary, you will be instructed to return the defective part or unit, packed securely, postage prepaid and insured by the

, to the address below. Enclose your name, address, dated sales receipt, and a brief explanation of the defect. There may be

’s location.

If you have a problem, please contact our Customer Care Centre below for help.

, please call the toll-free number listed below. Many problems can be solved in

Asst. #45130 U.S. English REV 0

® is a registered trademark and

TM is a trademark of Spin Master Ltd.

IN CHINA.