SteadiBoost
Wireless Charger
- F309W
Intelligent Power Technology
ControlHeat™ Technology (Overheat Protection)
ControlLight™ Technology
ControlSlip™ Technology
Smart IC Chip Protection
USB Adapter
USB Cable
USB Type-C Port
™
Compact I
The blue LED indicator light will automatically turn o after
60 seconds of intial charging.
If you detach a charging smartphone from the charging pad,
the blue LED will turn o and go into standby mode.
1.
Plug the USB Adapter into a power socket.
2.
Connect the USB Charging Cable to the USB Adapter and
USB Type-C port to the charging pad.
3.
After LED indicator ashes blue and red once, the charger
enters into standby mode.
LED ashes blue and red once
and turns o.
red
Use AC adapters with over 9V༉2A / QC2.0(18W)
in power supplty output
Please attach the provided Non-Slip Pad for maximum slip
prevention.
F309W
Note
B Class Equipment (Equipment for home use)
* This product is mainly for home use with radio wave
acceptability registration; therefore, it can be used in all areas.
• Input: 5V༉2A, 9V༉2A / QC2.0(18W)
• Output: 5W / 7.5W / 10W
• Dimensions: 70 x 70 x 11mm / 2.76 x 2.76 x 0.43in
• Weight: 42g / 1.48oz
FCC Compliance Statement: ISED Compliance Statement:
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: 1) this device may not cause harmful interference, and 2)
this device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment.
This transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
This device must operate with a minimum distance of 20 cm between the radiator
and user body.
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licenceexempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that
may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil
est conforme aux CNR d’Innovation, Sciences et Développement
économique Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
RF Exposure Compliance Statement:
This equipment complies with IC RSS‐102 radiation exposure limits set
forth for an uncontrolled environment. This equipment should be installed
and operated with minimum distance 20cm between the radiator and
your body.
Cet équipement est conforme aux limites d'exposition aux radiations IC
CNR‐102 établies pour un environnement non contrôlé. Cet équipement
doit être installé et utilisé avec une distance minimale de 20 cm entre le
radiateur et votre corps.
Loading...