Spicer STOCKING RECOMMENDATION - NEW DESIGN 170-190-590 User Manual
®
STOCKING RECOMMENDATION NEW DESIGN 170-190-590 SERVICE KITS AND PARTS FOR
MODELS PRODUCED ON OR AFTER JUNE 10, 2013
PART NUMBER INFORMATION
DATE: August 27, 2013
HAXL-PNI-42
TO: All Dana Aftermarket Group Spicer
Heavy Axle Customers
Affected Models: D/R170, D/R190, D/R590, S170, S190, S590
Below are two quick reference charts showing 170-190-590 NEW vs. OLD service part numbers and
Dana's stocking recommendations for the critical parts for the NEW design models.
Before the upcoming winter season approaches, you can quickly review the particular "usage" of the OLD
part numbers and begin to cross stock some of the NEW design part numbers. Doing so, you will be able
to service the NEW design axles if a carrier conversion is necessary or a repair situation is required.
Dana
NEW Dana
Part-No
504095 Yes
504097 Yes
140024 Yes
Recommends
Stocking of
NEW Parts New Part Description
KIT-SHI FT FORK & PIN (140008 FORK#)
KIT-DIFF LOCK SHIFT PARTS CONVE RSION
SLIDING CLUTCH
OLD Dana Part-No.
(Before June 10, 2013)
512944 or 512945
512946 or 512947
131104
504096 Yes
HS108-1 Yes
300HS100-1 Yes
504126 Yes
504127 Yes
504130 yes
504132 Yes
KIT-WHEEL DIFF SIDE GEAR w/ WASHERS
SIDE GEAR THRUST WASHE RS (MPQ-2)
SIDE PINION THRUST WASHERS (MPQ-4)
KIT-BEARING D170, S170E
KIT-BEARING D170D
KIT-BEARING R170, S170 4.10-7.17
KIT-BEARING R170D, S170D 4.10-7.17
513868
not used in O LD
models
not used in O LD
models
514238
514011
514014
514240
Dana Aftermarket Dana Holding Corporation www.spicerparts.com www.dana.com
1 of 3
This chart shows the same cross stocking part numbers (NEW vs. OLD) but these should only be
ordered and stocked if actual repairs or carrier conversions on newer models are being performed.
Always be certain to double check the carrier design level before ordering replacement parts.
NEW Dana
P art-No New Part Description
KIT-BEARING ALL D190, D190D, D/S590,
504128
504129
504131
D/S 590D, S190E, S190DE
KIT-BEARING R170, S170 2.69-3.91
KIT-BEARING R170D, S170D 2.69-3.91, S190,
S190D 2.53-4.78
OLD Dana Part-No.
(Before June 10, 2013) Notes
514012
514013
514015
Note - Bearing kits vary by model & ratios.
Usage w ill vary by customer current
m odel year truck, fleet size and specific
axle model. Review and stock as
necessary.
504133
139996
139997
139998
139999
140000
140001
140002
140003
140004
504134
504135
504136
504137
504138
504139
504140
504141
504142
504143
132480
132481
132482
132483
132484
132485
132486
132487
139992
139993
090311
140012
140014
140019
140020
KIT-BEARING S190-S190D 5.25-7.83
CASE-DIFF FLG HALF
CASE-DIFF FLG HALF
CASE-DIFF FLG HALF
CASE-DIFF PLAIN HA LF-(Dif f Lock Design)
CASE-DIFF PLAIN HA LF-(Dif f Lock Design)
CASE-DIFF PLAIN HA LF-(Dif f Lock Design)
CASE-DIFF PLAIN HA LF
CASE-DIFF PLAIN HA LF
CASE-DIFF PLAIN HA LF
KIT-WHEEL DIFF CASE Kit Contains: 139996, 140004 & 131473
KIT-WHEEL DIFF CASE Kit Contains: 139997, 140003 & 131473
KIT-WHEEL DIFF CASE Kit Contains: 139998, 140002 & 131473
KIT-WHEEL DIFF CASE Kit Contains: 139996, 140003 & 131473
KIT-WHEEL DIFF CASE Kit Contains: 139997, 140002 & 131473
KIT-WHEEL DIFF CASE (Diff Lock Design) Kit Contains: 139997, 139999 & 131473
KIT-WHEEL DIFF CASE (Diff Lock Design) Kit Contains: 139997, 140000 & 131473
KIT-WHEEL DIFF CASE (Diff Lock Design) Kit Contains: 139998, 139999 & 131473
KIT-WHEEL DIFF CASE (Diff Lock Design) Kit Contains: 139996, 140001 & 131473
KIT-WHEEL DIFF CASE (Diff Lock Design) Kit Contains: 139996, 140000 & 131473
CARRIER SUB -ASSY R170, S170
CARRIER SUB-ASSY R170D, S170D
CAR RIER SUB-ASSY R190, R190D, S190,
S190D
CARRIER SUB-ASSY D170, S170E
CARRIER SUB-ASSY D170D
CAR RIER SUB-ASSY D190, D190D, D590,
D590D, S590, S590D, S190E, S190DE
CARRIER SUB-ASSY S170R
CARRIER SUB-ASSY S190R
BEARING ADJUSTER-FLG HALF
BEARING ADJUSTER-PLAIN HALF
COTTER PIN (MPQ-2)
BEARING CUP (mates w/ 140014)
BEARING CONE (mates w / 140012)
BEARING CONE (mates w / 140020)
BEARING CUP (mates w/ 140019)
514016
131027
new
131029
131759 & 131752
131476 & 131760
new
new
131478
131479
513986, 513987,
513988
513989, 513990,
513991, 504123,
504124, 504125
513999
514000
514002
513997
513998
514001
-----
-----
131042-131048 &
131044-131041
not used in OLD
models
131042-131048 &
131044-131041
Note - Both NEW and OLD design wheel
differential cases are used in conbinations
and vary by model and ratio. Usage w ill
vary by customer current model year
truck, fleet size and specific axle model.
Review and stock as necessary for ratio
changes or specific rebuilds.
Note - New carrier sub-assemblies should
only be ordered if required for a specific
rebuild.
Note - New bearing adjusters and cotter
pin should only be ordered if required for
a specific rebuild.
Note - New design mated bearing cones
and cups are provided in bearing kits.
Order individual parts only if necessary.
Dana Aftermarket Dana Holding Corporation www.spicerparts.com www.dana.com
Page 2 of 3
Loading...