Spicer Shift Fork Spring Installation

Spicer

Drive Axles

Information Sheet: SHIFT FORK SPRING PIN INSTALLATION

Affected Models: Various Dana Diff Lock models

Dana diff lock design shift forks utilize a spring pin to hold the sliding clutch onto the shift fork. If removing or assembling the spring pin, shift fork or sliding clutch follow the procedures below.

Note: In some Dana Shift Fork kits or sub-assemblies, the spring pin may have been “pre-installed” into the shift fork so the pin is not lost in shipping. Be sure to follow and complete the “assembly” procedures when installing the sliding clutch onto the shift fork.

• Disassembly: Use a pin punch to remove spring pin from the fork leg. Remove sliding clutch.

• Assembly: To assemble the individual parts (shift fork, spring pin & sliding clutch), insert the shift fork onto the sliding

clutch. Using a hammer, drive the spring pin thru shift fork pin hole opening until flush to the outer portion of the shift fork surface. This will lock the sliding clutch in place.

For any other specifications or service assistance call 1-877-777-5360 or visit www.spicerparts.com.

P/N: SHAIS209A