SPI 18-010-9, 19-008-2, 19-009-0 Operation Manual
Zero Setting:
Close the jaws and
ensure that the zero
position is set after
battery installation
by pressing the
[0] button.
Calibration:
It is recommended that this precision measuring
tool be calibrated at a periodic interval as follows:
• Annually
• At an interval that ensures that the accuracy is
not compromised between calibrations intervals
• As outlined in your company's quality manual
Battery Installation:
Button:
A short press of the button will turn on or off
the caliper. Please note that the caliper will
automatically shut off after 5 minutes of non-use.
IN/MM/F Button:
Shortly press the button to switch between Inch,
Metric (mm) and Inch Fraction reading.
Digital Caliper
(Inch/Metric/Fraction)
Operation Manual
0 - 6" 18-010-9
0 - 8" 19-009-0
0 - 12" 19-008-2
© 2016 Swiss Precision Instruments, Inc.
18-010-9 TRI-FOLD ......indd 1 2/7/17 8:21 AM
Table A
1 Beam
2 Slider (moveable)
3 Battery holder
4 Slider locking screw
5 Internal measurement
6 Step measurement
7 External measurement
8 Digital display
9 Thumb wheel
10 Depth measurement
Operating Instruction:
Avoid exerting excessive force when measuring as
it may cause an incorrect reading and deformation
of the measuring jaws.
Normal Care: Clean all measuring surfaces and
the beam (1) with a dry clean cloth prior to the
initial use to remove protective oil.
Specications:
Range Resolution Accuracy
0 - 6" 0.0005" ±0.001"
0 - 8" 0.01mm
0 - 12" 1/128th
±0.0015"
External (outside) work piece feature:
Use the thumb wheel (9) to move the slider (2) until
the external measuring jaws (7) make contact with
the work piece feature.
Internal (inside) work piece feature:
Use the thumb wheel (9) to move the slider (2) until
the internal measuring jaws (5) make contact with
the work piece feature.
Depth work piece feature:
Place the end of the beam
(1) on the outermost side
of the feature and extend
the depth bar (10) to the
bottom of the feature.
Step work piece feature:
Place the slider (2) step measuring face (6) on
the outside of the feature. Extend the beam (1)
until the beam step measuring face (6) touches
the other side of the work piece feature.
Methods of Measurement:
Please refer to the enclosed warranty card
for warranty information.
1
10
8
9
2
3
4
5
6
7
18-010-9 TRI-FOLD ......indd 2 2/7/17 8:21 AM
Loading...