Sphere Alarm SPH010442 User Manual

SPH010442

Sphere Alarm System:

Pet Immune Motion Detector User Guide

Pet Immune Motion Detector

3.9 6 10.4 15

4m

2.1m

15m2.1 3.1 5.9

Introduction

This sensor is meant to be mounted in a room to detect human motion. The device
detects human body movement via its infrared sensor and sends a signal to the Base
Unit. You can either use the adhesive backing or drill holes in the wall for use with the
included anchors and screws. Place the Motion Detector sensor as high up in the room
as it can go-preferably 7 to 8 feet (2 - 2.5 m). The mount should be level and the detection
window turned to capture most of the room. If the room is smaller, the sensor will
not need to be placed as high on the wall. If placing the detector in a room with many
windows, you shouldn’t face the detection window directly towards them.

Included

• Motion detector

• Mounting bracket

• Adhesive strip

• 2 screws

• 2 wall anchors

• 2 AA batteries

Inside View

AA 1.5V

AA 1.5V

Magnetic SliceDetection Window

Infrared sensor

Detect-Interval
Time Setting Switch
(every 5 secs or 5 mins)

On/O Switch

LED Indicator

Stainless-Steel Bead

Bracket

2

Operating Instructions

Pairing with the Base Unit

• Scan the QR code printed on the sensor.

• Pairing is confirmed in the app.

Installation

• Open the case and remove the battery’s insulating strip.

• Pair with the base station using the Sphere Alarm app.

• Fix the bracket with screws to a wall, connect the sensor to bracket, adjust
at a proper angle.

• Install at a height of 5.9 - 7.9 ft. (1.8 - 2.4 m) from ground.

Make sure to avoid installing near stairs or an exit where a pet frequently passes through.
Avoid installing the sensor near a door, air-conditioner, in direct sunlight, by
a heat source or under rotating objects like a fan.

Positioning the Motion Detector

Place detector
7 - 8 feet high
(2 - 2.5m)

Side View

(Do not angle the detector downwards.)

3