Sphere 400-03520 Installation & Operation Manual

Low Battery warning

LED strobe light will flash every 10 seconds when the batteries need to be replaced

Tamper proof

If the receiver is removed from bracket while the system is armed, the siren will sound.

Page 4

Sphere

Wireless Security System

Part Number 400-03520

Installation & Operation Manual

Introduction

Sphere 400-03520 Wireless Security System is a wireless receiver with build-in siren & LED
strobe light.
The Sphere 400-03520, Wireless Security System can learn up to 2 Remotes 400- 03554 and
up to 5 accessory devices, such as:
Wireless door sensor 400-03550
Wireless motion sensor 400-03552

Product Specification

*** For indoor use only ***

Specification:

Frequency Range: 433.92Mhz
Operating Range: Up to 100 feet line of sight
Loud Audible Alarm: > 105Db@1meter
Strobe Light: 4 X LED lights
Operating Temp.: -15°C~ 60°C (5°F~140°F)
Battery: 4pcs x AA Energizer Batteries

Installation

1. Remove the bracket from the siren by pressing the locking tab, and gently slide up the
receiver housing.

2. Use screws or adhesive tape to fix the bracket on the required location.

3. Once the bracket is secured slide the siren back into the bracket.

Page 2

Programming

Note: If the Tamper/Program switch is held down while the receiver is being powered up with

the 4pcs x AA Energizer batteries, the memory will be erased and all accessory devices
previously programmed will be erased from the memory.

When fitting a new system for the first time, skip the following steps as the system has already
been factory programmed, the two transmitters, the wireless motion sensor and the wireless
door sensor are already programmed. The following steps need to be followed only when
adding extra accessory devises onto the system.

1 Press and hold down the Tamper/Program switch and power up by inserting the

4pcs x AA Energizer batteries into the Wireless Receiver.

2 Immediately after the receiver is powered up, the LED strobe light will flash three

times and the GREEN LED will stay lit to confirm that the unit is in learning mode (all
previously programmed accessory devices are now erased from the memory) after
the third flash release the Tamper/Program switch.

3 Trigger (one at a time) all the accessory devices and remotes to be programmed,

the LED strobe light will flash once every time an accessory product is programmed
in to the wireless receiver.

4 Once all accessory devices are programmed into the receiver exit learning mode by

pressing and releasing the Tamper/Program switch. The LED Strobe light will flash
two times and the green LED will turn “Off” to confirm that the system has exit
learning mode

5 Mount the Wireless Receiver onto the bracket, the system is ready for use.

Operation

1. Press the Arm button on the transmitter, the siren will emit one arm chirp and the LED
strobe will flash once to indicate that the system is armed.

2. Press the Disarm button on the transmitter , the siren will emit three disarm chirps and
the LED strobe light will flash three times to indicate that the system is disarmed.

3. When triggered the siren will sound for 30 seconds, the LED strobe light will continue to
flash until the system is disarmed with the remotes.

Page 3