Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
OPERATING INSTRUCTIONS
Continuity Tester
Model CT6101
IMPORTANT: RECEIVING INSTRUCTIONS Visually inspect
all components for shipping damage. If you find damage, notify the
carrier at once.
Shipping damage is NOT covered by warranty. The carrier
is responsible for all repair or replacement costs resulting from
damage in shipment.
Figure 1
BEFORE USE:
READ ALL OPERATING INSTRUCTIONS BEFORE USE. Use extreme caution when checking electrical circuits to avoid
injury due to electrical shock. Sperry Instruments assumes basic knowledge of electricity on the part of the user and is
not responsible for any injury or damages due to improper use of this tester.
OBSERVE and follow all standard industry safety rules and localelectrical codes. When necessary call a qualified
electrician to troubleshoot and repair the defective electrical circuit.
1
SPECIFICATIONS:
Operating Range: Use only on non-energized (“dead”) circuits.
Indicators: Visual Only
Operating Environment: 32° - 104° F (0 - 32° C)
80% RH max., 50% RH above 30° C
Altitude up to 2000 meters. Indoor use.
Pollution degree 2. Accordance with IED-664.
Cleaning: Remove grease and grime with clean, dry cloth.
Bulb Replacement Information: Type - TL3, Base - Mini-screw, Wattage - (0.25watts), Voltage - (2.33volts)
OPERATION:
WARNING
Only use on non-energized (“dead”) circuits.
1. Before using and to assure the batteries are good, test the tester by touching the metal tip and the
alligator clip to each other. If the unit is operating properly the lamp inside the tester will glow.
If the lamp does not glow then replace the batteries.
2. To test for continuity, attach the alligator clip to one end of the circuit or component to be tested and
then touch the other end with the metal probe tip. If the circuit is continuous (shorted) then the lamp in
the tester will glow. If the lamp does not glow then the circuit is “open” or intermittent.
BATTERY INSTALLATION:
Refer to Figure 2: Turn #1 counter clockwise to access battery compartment.
Figure 2
1
2
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
SPR_TL_063_0516_CT6101
3
Loading...