Parts Ordering Information........................................................................................................................................ 2
Model Identification ................................................................................................................................................... 3
Graphic Panel, Control Hood and Controls (Drawing 1 of 5) .................................................................................... 4
Graphic Panel, Control Hood and Controls (Drawing 2 of 5) .................................................................................... 6
Graphic Panel, Control Hood and Controls (Drawing 3 of 5) .................................................................................... 8
Graphic Panel, Control Hood and Controls (Drawing 4 of 5) .................................................................................. 10
Graphic Panel, Control Hood and Controls (Drawing 5 of 5) .................................................................................. 12
Cabinet Top and Control Hood Rear Panel ............................................................................................................ 14
Loading Door with Drying Rack .............................................................................................................................. 16
Lower Access Panel, Front Panel and Seal............................................................................................................ 18
Motor, Exhaust Fan and Belt .................................................................................................................................. 20
Front Bulkhead, Air Duct, Felt Seal and Cylinder ................................................................................................... 22
Rear Bulkhead, Felt Seal, Cylinder Roller and Terminal Block............................................................................... 24
Heater Box Assembly (Drawing 1 of 2) ................................................................................................................... 26
Heater Box Assembly (Drawing 2 of 2) ................................................................................................................... 28
Gas Valve, Igniter and Gas Conversion Kits........................................................................................................... 30
Cabinet, Exhaust Duct and Base ............................................................................................................................ 32
Power Cord (Drawing 1 of 2) .................................................................................................................................. 34
Power Cord (Drawing 2 of 2) .................................................................................................................................. 36
Motor Connection Block and Terminal Extractor Tools........................................................................................... 40
Parts Index .............................................................................................................................................................. 43
All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any
means without the expressed written consent of the publisher.
If literature or replacement parts are required, contact the source from whom the machine was purchased or contact Alliance Laundry Systems at
(920) 748-3950 for the name and address of the
nearest authorized parts distributor.
Nameplate Location
When calling or writing about your product, be
sure to mention model and serial numbers. Model
and serial numbers are located on nameplate(s)
as shown.
For technical assistance, call either of the numbers listed below: