Speed Queen DRY2023N Installation Manual

Installation Instructions

for Dryers

Inside ......................................

Dimensions ........................................................................ 3

Before You Start ................................................................ 4

Installing the Dryer ............................................................ 5

Installer Checklist ................................................ Back Cover

Para bajar una copia de estas instrucciones en espafiol, visite www.speedqueen.com.

Keep these instructions for future reference. (If this machine changes ownership, this manual must accompany machine.)

Date Purchased Model Number Serial Number

www.speedqueen.com

Part No. 512061R3

June 2007

WARNING

FOR YOUR SAFETY, the information in this manual must be followed to minimize the risk of

fire or explosion or to prevent property damage, personal injury or death.

W033

° Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or

any other appliance.

• WHAT TO DO IF YOU SMELL GAS:

- Do not try to light any appliance.

- Do not touch any electrical switch; do not use any phone in your building.

- Clear the room, building or area of all occupants.

- Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's

instructions.

- If you cannot reach your gas supplier, call the fire department.

• Installation and service must be performed by a qualified installer, service agency or the gas

supplier.

W052

WARNING

FOR YOUR SAFETY

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance,

W053

The following information applies to the state of Massachusetts, USA.

• This appliance can only be installed by a Massachusetts licensed plumber or gas fitter.

• This appliance must be installed with a 36 inch (91 cm) long flexible gas connector.

• A "T-Handle" type gas shut-off valve must be installed in the gas supply line to this appliance.

• This appliance must not be installed in a bedroom or bathroom.

means without the expressed written consent of the publisher.

2 © Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT 512061

Dimensions

__ 22.38 in.

(56.85 cm) /

23.5 in.

(59.7 cm)

* With leveling legs turned into base.

28 in. (1.1 cm)

(71.1 cm) *4.0 in.

_ 0.4 in. |

(10.2 cm)

ELECTRIC DRYERS

(68.3 cm)

DRY2203N

22.38 in.

8.0 in.

(20.3 cm)

23.5 in. 28 in.

(59.7 cm) '

*With leveling legs turned into base.

1 3/8 in. NPT Gas Connection

(71,1 cm)

15.4 in.

39.1 cm]

_- 0.4 in. (68.3 cm) *2.8 in.

(1.1 cm) (7 cm)

GAS DRYERS

26.9 in.

*4.0 in.

(10.2 cm)

2.3 in.

(6cm)

DRY2164N

512061 © Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT 3

Before You Start

Parts Included

Supplies

For most installations, the basic supplies you will need are:

,/6

An accessories bag has been shipped inside your dryer. It includes:

• Installation Instructions

• User's Guide

• Product Registration Card

• Dryer Rack Reply Card

• Warranty Bond

• Three screws (electric dryers only). Refer to

Connecting Power CoM sections in Step 4 of

Installation.

1 2 3 4 5 6 7 8

Safety Glasses Power Cord (Electric Models)

Wrench Screwdriver Level 5/16 Inch Socket Wrench

Duct Tape Teflon Tape (Gas Models)

Figure 1

WARNING

Any disassembly requiring the use of tools must be performed by a suitably

qualified service person.

DRY2023N

W299

4 © Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT 512061

Installing the Dryer

Step 1" Position and Level the Dryer

Install dryer before washer. This allows room for attaching exhaust duct.

Select a location with a solid floor. Dryers installed in residential garages must be elevated 18 inches (46 cm)

above the floor.

i :i

iP;i

No other fuel burning appliance should be installed in the same closet with the dryer.

The dryer must not be installed or stored in an area where it will be exposed to water and/or weather.

The dryers needs sufficient clearance and an adequate air supply for proper operation and ventilation, and for easier installation and servicing. (Minimum clearances are shown below).

A A -_.-C

FRONT VIEW SIDE VIEW 3 FRONT VIEW

*1L'

(w/o Closet Door) (Closet Door) (Closet Door)

Area Description Installation

A Dryer sides and rear clearance 0 in. (0 cm) 0 in. (0 cm) B Dryer top clearance 12 in. (30.5 cm) 12 in. (30.5 cm) C Dryer front clearance Not Applicable 2 in. (5.1 cm)

D Exhaust duct clearance to 2 in. (5.1 cm) 2 in. (5.1 cm)

combustible material

E Weather hood to ground clearance 12 in. (30.5 cm) 12 in. (30.5 cm)

F Distance from floor or ceiling to Not Applicable 3 in. (7.6 cm)

hole edge

G* Area of centered air openings in Not Applicable 40 sq. in./open (260 sq. cm)

closet door

*Louvered door with equivalent air openings is acceptable. (Minimum clearances are shown."

1 Closet Door 2 Centered Air Openings (G) (2 Openings

minimum)

3 Outer Wall of Enclosure

**NOTE: For new installations, locate top of wall vent 42 inches (106.7 cm) above floor to make venting easier to connect.

Free Standing/Alcove Closet Installation

D8231

Figure 2

Place the dryer in position, and adjust the legs until the dryer is level from side to side and front to back. The dryer must not rock.

WARNING

This gas appliance contains or produces a chemical or chemicals which can cause

death or serious illness and which are

known to the State of California to cause

cancer, birth defects, or other reproductive

harm. To reduce the risk from substances in the fuel or from fuel combustion, make sure this appliance is installed, operated, and

maintained according to the instructions in this manual.

Wl15

To reduce the risk of fire, DO NOT use

plastic or thin foil ducting to exhaust the dryer.

W354

D6691

Dryer Base Level

Leveling Leg

Figure 3

IMPORTANT: In mobile home installations, gas dryers MUST be permanently attached to the floor at the time of installation. Order No. 526P3 Dryer

Installation Kit (available at extra cost) for a manufactured (mobile) home installation. Follow

the instructions supplied with the kit.

Step 2: Connect Dryer Exhaust System

WARNING

To reduce the risk of fire and combustion

gas accumulation the dryer MUST be

exhausted to the outdoors.

To reduce the risk of fire and the

accumulation of combustion gases, DO NOT exhaust dryer air into a window well, gas vent, chimney or enclosed, unventilated

area, such as an attic, wall, ceiling, crawl

space under a building or concealed space

of a building.

W604

W045

• DO NOT use plastic or thin foil ducting. Rigid

metal duct is recommended.

/// ////

DO DON'T

DRY1915N

Figure 4

• Locate dryer so exhaust duct is as short as

possible.

• Be certain old ducts are cleaned before installing your new dryer.

• Use 4 inch (102 mm) diameter rigid or flexible metal duct.

• The male end of each section of duct must point away from the dryer.

• Use as few elbows as possible.

• Use duct tape or pop-rivets on all duct joints.

• Ductwork that runs through unheated areas must be insulated to help reduce condensation and lint build-up on pipe walls.

+ 11 hidden pages

Speed Queen DRY2023N Installation Manual

Specifications and Main Features

Frequently Asked Questions

User Manual