Speed Queen AFNE9BADGE8BWGASL, AFNE9BADEE8BW, AFNE9BADGE8BWGASN, ADGE8BWGASLP, ADGE8BWSGASN Installation Guide
...
Installation Instructions
for Dryers
Original Instructions
Keep These Instructions for Futur
CAUTION: Read the instructions before using the machine.
(If this machine changes ownership, this manual must accompany machine.)
e Reference.
www.alliancelaundry.com
Part No. D514685R5
August 2017
WARNING
Risk of fire. Highly flammable material.
W881
IMPORTANT: The electrical installation in the site shall
comply with the Australian Electrical Standards,
AS3000, SAA wiring rules, and such local regulations
that might apply. In Australia and New Zealand, installation must comply with the Gas Installations Standard
AS/NZS 5601 Part 1: General Installations.
The maximum drying load (dry weight) shall not exceed 9 kg [20
pounds].
Read all instructions before using unit.
WARNING
WARNING
• Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
• WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Clear the room, building or area of all occu-
pants.
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the
fire department.
• Installation and service must be performed by a
qualified installer, service agency or the gas supplier.
W052
FOR YOUR SAFETY, the information in this manual
must be followed to minimize the risk of fire or explosion or to prevent property damage, personal injury or death.
W033
IMPORTANT: Purchaser must consult the local gas
supplier for suggested instructions to be followed if
the dryer user smells gas. The gas utility instructions
plus the SAFETY and WARNING note directly above
must be posted in a prominent location near the dryer
for customer use.
WARNING
• Installation of unit must be performed by a qualified installer.
• Install clothes dryer according to manufacturer’s
instructions and local codes.
• DO NOT install a clothes dryer with flexible plastic venting materials. If flexible metal (foil type)
duct is installed, it must be of a specific type
identified by the appliance manufacturer as suitable for use with clothes dryers. Refer to section
on connecting exhaust system. Flexible venting
materials are known to collapse, be easily crushed, and trap lint. These conditions will obstruct
clothes dryer airflow and increase the risk of fire.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
W729R1
3 Part No. D514685R5
WARNING
To reduce the risk of severe injury or death, follow all
installation instructions. Save these instructions.
W894
WARNING
FOR YOUR SAFETY
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other
appliance.
W053
This product uses FreeRTOS V7.2.0 (www.freertos.org).
NOTE: For Australian models, the energy consumption
is measured as used once per week using the Perm
Press Automatic cycle with High Temperature and Dryness Dry at the rated load capacity of 7 kg.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
4 Part No. D514685R5
Table of Contents
Dimensions............................................................................................. 6
Installation............................................................................................. 8
Before You Start............................................................................................. 8
Supplies..................................................................................................... 8
Order of Installation Steps............................................................................8
Position and Level the Dryer............................................................................8
Connect Dryer Exhaust System...................................................................... 10
Exhaust Direction......................................................................................11
Exhaust System.........................................................................................12
Gas Dryers - Connect Gas Supply Pipe........................................................... 12
Reverse Door, if Desired................................................................................14
Wipe Out Inside of Dryer...............................................................................15
Plug In the Dryer.......................................................................................... 15
Electrical Requirements............................................................................. 15
Earth/Ground Instructions.......................................................................... 17
Recheck Steps.............................................................................................. 17
Check Heat Source........................................................................................17
Electric Dryers.......................................................................................... 17
Gas Dryers................................................................................................17
All Dryers.................................................................................................18
Installer Checklist.................................................................................19
©
Copyright 2017, Alliance Laundry Systems LLC
All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed
written consent of the publisher.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
5 Part No. D514685R5
Dimensions
DRY2638N_SVG
JK
I
H
G
F
E
D
C
B
A
DRY2639N_SVG
F
E
D
C
B
A
J
K
M L
I
H
G
1
Electric Models
A * 1027 mm [40.42 in.]
B * 1006 mm [39.61 in.]
C * 392 mm [15.44 in.]
D * 102 mm [4 in.]
Dimensions
E 391 mm [15.4 in.]
F 683 mm [26.875 in.]
G * 114 mm [4.5 in.]
H 10 mm [0.4 in.]
I 203 mm [8 in.]
J 711 mm [28 in.]
K 597 mm [23.5 in.]
NOTE: Exhaust openings are 102 mm [4 inch] metal
* With leveling legs turned into base.
ducting.
Gas Models
1. 3/8 in. NPT Gas Connection
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
6 Part No. D514685R5
Loading...