Spectrum Technologies AutoDialer 3419 Product Manual

AutoDialer

PRODUCT MANUAL

Item # 3419

Using Your AutoDialer

Thank you for purchasing an AutoDialer. This manual will
familiarize you with the features and operation of your new
AutoDialer. Please read this manual thoroughly before using
your instrument.

Item #3419 AutoDialer is compatible with #3672 Alarm Out­put Module or any other continuous, momentary, normally
closed (NC) or normally open (NO) dry contact voltage sen­sor. The AutoDialer will dial up to four numbers with a re­corded message up to 16 seconds when the sensor or output
module opens or closes the circuit.

The following instructions will simplify installation of an
AutoDialer with your WatchDog Weather Station.

Normally Open Activation Hookup

With WatchDog and #3672 Alarm Output Module

1. Program the AutoDialer message and number(s) per the
instructions included with the unit.

2. Program the AutoDialer to normally open (NO) and
momentary activation, no exit or entry delay per the in­structions on pg. 11 of your AutoDialer manual.

3. Trim or cut off the U-shaped terminals on the 4 wire
leads on the AutoDialer power/alarm cable so they will
fit into the terminal connectors on the Alarm Output
Module. Splice wire extension if needed.

4. Connect the RED and YELLOW l eads from the Auto­Dialer power/alarm cable to the COM terminal on the
Alarm Output Module.

5. Connect the WHITE and BLACK leads from the Auto­Dialer power/alarm cable to the N.O. terminal on the
Alarm Output Module.

6. Set the Alarm Output in the SpecWare™ launch options
screen to the desired parameters and launch the station.

2

Your AutoDialer is now ready for use. It is strongly recom­mended that you perform a test to ensure functionality. Test
instructions are provided in the AutoDialer Manual.

Activation Hookup with Other Sensors or Control Sys­tems

Please refer to the AutoDialer Manual or 3rd party manufac­turer instructions. Wiring instructions are provided for nor­mally open, normally closed, or voltage level activation
setup.

Important Notes:

The power/alarm cable provided with the AutoDialer has been
tested with up to a 400ft. extension using 24-gauge wire. It is
estimated this wire can be extended up to an 750ohm imped­ance. You can test impedance using a volt meter with imped­ance capability. If in doubt, test your application first!

When using rainfall as an alarm actuation in SpecWare, be
aware that the relay will not activate/deactivate unless the
amount of rain that falls during the logging interval exceeds
the set point.

The set point seen in the SpecWare launch options screen may
change slightly to ensure functionality with the selected pa­rameters.

3

Warr a n t y

This product is warranted to be free from defects in material or
workmanship for one year from the date of purchase. During the
warranty period Spectrum will, at its option, either repair or replace
products that prove to be defective. This warranty does not cover
damage due to improper installation or use, lightning, negligence,
accident, or unauthorized modifications, or to incidental or conse­quential damages beyond the Spectrum product. Before returning
a failed unit, you must obtain a Returned Materials Authorization
(RMA) from Spectrum. Spectrum is not responsible for any pack­age that is returned without a valid RMA number or for the loss of
the package by any shipping company.

12360 S. Industrial Dr. E

Plainfield IL 60585

[phone] or [phone]

Fax [phone]

E-Mail: [e-mail]

www.specmeters.com