Assembly Instructions
Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts
or accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
(1) 052510
Worksurface assembly
(15) 026064
1/4-20 x 5/8” PHMS
(2) 050524
#8 x 3/4” PH TEK
screw
(2) 041943
1/4-20 Locknut
(2) 021554
1/4-20 x 50mm
JC bolt
(1) 044234
Cord channel
(2) 0102049
Z-bracket
(2) 036281
Dual unit-to-unit
bracket
1. Attach Brackets & Cord Channel
1. Place the worksurface assembly face-down onto a non-abrasive surface.
2. Attach the two Flip-top support brackets and Cord Channel with
1/4-20 x 5/8” PHM screws as shown in Figure 1.
Evolution Corner Connector (30”D)
(2) 036207
Flip-top support
bracket
(5) 1/4-20 x 5/8”
PHMS
38906
(1) 025039
4mm Hex wrench
Phillips
screwdriver
or
Drill with
Phillips
driver
Tools Required
4mm Hex
wrench
(included)
Flip-top
support
brackets
Cord channel
Worksurface
assembly
Figure 1
052525R5 Page 1 of 2
2. Attach Brackets to Desks
1. Attach the ‘Z’ Brackets to the rear of each desk as shown in Figure 2 using
(1) 1/4-20 x 50mm JC Bolt and Locknut. Tighten completely. Note: The
elongated hole on the ‘Z’ Bracket will attach to the Corner Connector.
2. Using an electric drill with a Phillips bit, install a #8 x 3/4” PH TEK Screw
through the ‘Z’ Bracket and into the leg. Be careful not to strip-out the screw.
3. Attach the Dual Unit-to-Unit Brackets to the front of each desk as shown. Do
not tighten completely.
Front of desk
1/4-20 x 50mm JC Bolt
Flip section
open
Z-bracket
#8 x 3/4” PH TEK screw
1/4-20 Locknut
Cord channel
Leg
3. Attach Corner Connector to Desks
1. Align both desks 90° to each other leaving about 6” between the corners as shown in Figure 3.
2. Place the Corner Connector onto the brackets and align the mounting holes.
3. Attach with (6) 1/4-20 x 5/8” PHM screws, but do not tighten completely-after the screws are
started, alignment of the desks may be necessary.
4. After alignment is satisfactory, tighten all screws.
Dual
unit-to-unit
bracket
(2) 1/4-20 x 5/8” PHMS
Figure 2
Corner connector
6
30”D Evolution desk
30”D Evolution desk
Figure 3
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
© 2016 Spectrum Industries Inc., All rights reserved.
052525R5 Page 2 of 2
Loading...