Spectrum 37256, 37254, 37255, 37257, 37258 Assembly Instructions Manual

Assembly Instructions:

Note

: The hole in the center of the mounting flange does not require a JC bolt into the work surface

To purchase parts or accessories, please contact us at

044541
1/4-20 x 20mm JC bolt
(13) for cord channel
(8) for modesty panel

Before you begin, please make sure all parts and proper quantities are
included. Any parts damaged during shipment must be reported within
15 days of receipt. To report information regarding damages or if you
have any questions, please call 1-800-235-1262.

www.spectrumfurniture.com

1-800-235-1262

Thank you for choosing Spectrum products!

(1) 025039
4mm Hex wrench

Cord Channel

Cord Channel / Modesty Panel

for Flex Training Tables

Cord Channel
37256 - for 48" table
37257 - for 60" table
37258 - for 72" table

Attaching cord channel to table

A. Flip the table upside-down onto a non-abrasive surface.
B. Remove the 4 rear-most PHM screws from each leg mounting plate.
C. Attach the front half of the cord channel to the work surface (through the leg mounting plates)

as shown using 1/4-20 JC bolts and tighten securely. Figure 1.

D. Attach the rear half of the cord channel to the work surface (through the leg mounting plates)

as shown using 1/4-20 JC bolts and tighten securely.

E. Align the cord channel mounting holes from both halves, and attach together with JC bolts.

: The rear half will overlap the front, and the JC bolts will thread into the front half.

Note

Modesty Panel Cord Channel &

Modesty Panel

Modesty Panel
37253 - for 48" table
37254 - for 60" table
37255 - for 72" table

Tools Required:
Phillips screwdriver
4mm Hex wrench (included)

.

1/4-20 JC bolts

Front half of cord

channel

Leg mounting plate

Rear half of cord

channel

JC bolt not

necessary here

Wor k s ur fa c e

Figure 1

0106710X Page 1 of 3

Attaching modesty panel to table

A. Flip the table upside-down onto a non-abrasive surface.
B. Remove the two rear-most PHM screws from each leg mounting plate.
C. Align the modesty panel mounting holes with the work surface inserts and attach (through the leg mounting

plates) with 1/4-20 JC bolts as shown. Figure 2.

: The hole in the center of the mounting flange does not require a JC bolt into the work surface.

Note

D. Orient the two modesty panel braces as shown, and secure with JC bolts.
E. Tighten all fasteners securely.

1/4-20 JC bolts

Modesty Panel

Modesty

Panel
Brace

Modesty Panel

Brace

Leg mounting plate

Work surface

Figure 2

0106710X Page 2 of 3