WatchDog™
Docking Station
User’s Manual
Catalog #3655K2
For use with WatchDog 100
Spectrum
Technologies, Inc.
What is the WatchDog 100 docking station?
The docking station allows the host computer to
communicate with the WatchDog 100 temperature data
loggers. In addition, it also functions as the PC interface
for other WatchDog loggers
Connecting the docking station to the PC.
The docking station has a serial port interface. To connect
to a PC that does not have a serial port you will need to
purchase a USB to serial adapter, item 3661USB.
Connecting the WatchDog 100 to the docking
station.
The WatchDog 100 simply snaps onto the docking station
as shown in the photo below. While attached to the
docking station, the logger may be read and/or relaunched.
Removing the WatchDog 100 from the docking
station.
Grab the 100 on two sides and pull up on a slight angle (as
pictured) Do not grab the corner of the backing and pull as
the severe bending that results may separate the backing
from the logger.
2
Interfacing the docking station with other
dataloggers.
If you have other WatchDog, loggers, it is not necessary
to disconnect the docking station and reconnect the gray
cable that comes with the SpecWare software. The
docking station is equipped with a serial plug and any of
these loggers may be accessed with the docking station as
illustrated in the photo above.
3
Spectrum
Technologies, Inc.
Spectrum Technologies, Inc.
12360 S Industrial Dr E
Plainfield, IL 60585
(800) 248-8873 or (815) 436-4440
Fax (815) 436-4460
E-Mail: info@specmeters.com
www.specmeters.com
Loading...