Spectrum 3415F, 3415FQF, 3415FSE User Manual

User manual

Catalog #s 3415F,

3415FQF, 3415FSE

QUANTUM LIGHT METERS

Spectrum

Technol ogies, Inc.

Thank you for purchasing a Field ScoutTM Light Meter. This
manual describes the features and operation of the following
meters:
3415F Quantum Light Meter (Solar Calibration)
3415FQF Quantum and Foot-Candle Meter
3415FSE Dual Solar/Electric Quantum Meter

Using the Meter

1. Turn the dial clockwise to the “ON” position. Dual mode
meters (3415FQF, 3415FSE) have two “on” settings, one
to either side of “OFF”.

2. Hold the meter vertical for accurate readings.

3. Turn the meter off after use to conserve battery power.

Changing the Battery

The Field Scout Light Meters use a standard 9V battery. To
change the battery:

1. Remove the two screws on the back of the meter.

2. Lift the back from the bottom of the meter.

3. Remove the old battery from the connector, and snap the
new battery in its place. Set the battery into the front half
of the case.

4. Connect the front and back of the case at the top (by the
sensor).

5. Close the case and tighten the two screws.

Accuracy

The Field Scout Light Meters are accurate to ±5%. Cosine
correction is accurate to ±3% at 45°, and ±7% at 80°.

[phone] or [phone] between 7:30 am and 5:00 p.m. CST

2

For support, or to place an order, call:

Spectrum Technologies, Inc
12360 S. Industrial Dr. East

Plainfield, IL 60585

e-mail: [e-mail].

www.specmeters.com