Spectralink RFP5 1G9 UserMan
Polycom® KIRK® Base Station
1.8/1.9 GHz
User Guide
1 Introduction
The base station is only intended for use with a
wireless server. The base station is not
intended to be connected directly to the PSTN
network.
two internal antennas and supports antenna
diversity. The base station is also able to carry
out a handover between the RF channels
under the same base station, and handles four
DECT speech channels simultaneously. The
base station is able to frame synchronize with
other base stations under the same wireless
server.
Transmission lenght is up to 2 km/1.2 miles on
a twisted pair, e.g. cat.4, between the base station and wireless server. The base station is
also power supplied from this connection
The base station is designed with
(maximum supply 1.5 W). The DECT radius of
coverage is up to 600 meters/1960 feet with a
handset in free sight.
2 Installation
First you have to determine where to install
the base station to have the right coverage.
The average coverage within buildings is 75
meters/246 feet. The coverage depends on the
construction of the building, architecture and
choice of buildings materials. You may have to
use the Deployment Kit to optimize your
installation.
The base station is to be mounted vertically on
the wall.
To mount the base station on the wall:
Holes for wall mounted screws
Power supply
1 Use a twisted pair cable, e.g. cat.4 between
the base station and wireless server with
an RJ11 connector at the base station end of
the cable. Connect the cable to the plug
using the two inner connectors of the plug.
2 Mount the base station onto the wall using
the screws accompanyiing the base station.
3 Connect the base station to the wireless
server.
After the wireless server is powered up again,
a cable lenght measurement is needed.
Note: Cable dimensions min. as AWG 26.
Important Safety Instructions and Product Information
Before using your telephone equipment, you
should always follow basic safety instruction
to reduce the risk of fire, electrical shock and
injury to persons, and damage to property.
1 Read and understand all instructions 2 Follow all warnings and instructions
including those marked on the product
3 Unplug this product before cleaning. Do
not use liquid cleaners or aerosol cleaners.
Use damp cloth for cleaning
4 Do not install the telephone equipment in
the bathroom or near a wash bowl, kitchen
sink, or laundry tub, in a wet basement, or
near a swimming pool
5 Slots or openings in the cabinet back and
bottom of the equipment are provided for
ventilation to protect it from over-heating.
These openings must not be blocked or
covered.
6 The equipment is to be connected only to
the PoE networks without connection to
outside plant.
7 The equipment is to be connected to a UL
listed PoE server
8 Do not overload wall outlets and extension
cords as this can result in fire or electrical
shock.
9 Never push objects of any kind into this
product through cabinet slots as they may
touch dangerous voltage points or short
out parts that could result in fire, electrical
shock, or injury. Never spill liquid of any
kind into this product.
10 To reduce the risk of electrical shock or
burns, do not disassemble this product.
Opening or removing covers may expose
you to dangerous voltages, dangerous electrical current, or other risks. Incorrect reassemble can cause electrical shock when the
appliance is subsequently used. If the
product need repair, consult your dealer.
11 Refer servicing to qualified service person-
nel under the following conditions:
AQ If liquid has been spilled into the product
BQ If the product has been exposed to rain or
water
Loading...