SpectraLink PTE140, PTX140, e340, i640 Technical Bulletin

Technical Bulletin CS-04-04

High Noise Mode functionality on e340 or i640 Wireless Telephones

Date: June 03, 2004

Software Versions: See Below

Hardware Revisions: PTE1xx, PTX1xx

Originator: Matt Jerger

Approvers: Wayne McAllister

Gary Bliss

Product Type: NetLink Wireless Telephones

Access Level: General

Status: Approved

Revision: A

Problem

When changing the High Noise Mode setting in the Wireless Telephone, the change
does not take place until the phone is turned off and back on again. On some protocols,
changing the High Noise Mode has no effect on that setting.

Description

The following list of software versions (based on protocol) is where the problem will
occur. If you have this version, or an earlier one, then you will have to re-boot the
Wireless Telephone after you have changed the High Noise Mode setting.

SRP – 89.104
Cisco SCCP - 91.035
Avaya CCMS - 96.024
Nortel UNIStim - 97.030 (No change occurs)
H.323 - 99.012
Inter-Tel Axxess - 100.011 (No change occurs)
Mitel ICP - 101.004 (No change occurs)

Resolution
The following list of future releases will correctly fix the problem. The user will no longer
have to re-boot the Wireless Telephone to get the change to take effect. Release dates
are unknown at this time. Please check www.spectralink.com

SRP – 89.110
Cisco SCCP - 91.039
Avaya CCMS - 96.025
Nortel UNIStim - 97.039
H.323 - 99.013
Inter-Tel Axxess - 100.012
Mitel ICP - 101.007

THE INFORMATION PROVIDED IN THE SPECTRALINK TECHNICAL BULLETIN IS PROVIDED "AS IS" WITHOUT W ARRANTY OF ANY KIND. NO
OBLIGATION OR LIABILITY WILL ARISE OUT OF, SPECTRALINK RENDERING TECHNICAL OR OTHER ADVICE OR SERVICE IN CONNECTION

SpectraLink Corporation • 5755 Central Avenue • Boulder, Colorado 80301 • 303.440.5330

HEREWITH.

for software updates.