Spectracide ACCUSHOT Operating Instructions Manual

People and pets should not be allowed on treated areas until product has dried.

DIRECTIONS FOR USE

Before using, test surfaces to be treated for color fastness by applying to a hidden area. Wait 1
hour, then wipe with cloth. If color is removed from the test area, do not use Nature's Miracle®
Urine Destroyer on those surfaces. Do not use on untreated hardwood, leather, suede, silk or
wool specialty fabrics. Always use this product full strength. Do not dilute. Always use Nature's
Miracle Urine Destroyer products first. Other cleaners and detergents may fail and chemically
"set" stains that will be impossible to remove.

FOR STAIN REMOVAL

1. Wipe up as much of the stain as possible, then thoroughly soak stain with this product.

2. Allow to work for 10 minutes, then blot up stain with a clean cloth.

3. Allow area to dry for 24 hours.

4. For severe, old or stubborn stains an carpeting or fabrics (feces or vomit/hairball),

follow steps 1-2 above and follow with gently scrubbing the stain with a soft bristle brush
for 1 minute, then allow to dry for 24 hours.

FOR ODOR ELIMINATION

1. Wipe up excess odor-causing material, then thoroughly soak area with this product.

Saturation is important so that this product can penetrate deeply to the odor source. In
carpeting, this may mean lifting carpet and applying directly to the pad and floor.

2. Do not wipe up excess.

3. Leave treated area wet and let it air dry. Odor will fade as this product dries. Complete

odor elimination only happens when all odor sources are reached.

4. For severe, old or stubborn odors on carpeting or fabrics, saturate a towel with water and

lay over the treated area, letting sit for 1 to 2 hours. This will allow the bacterial
enzymatic activity to break down and consume more of the odor.

OPERATING INSTRUCTIONS FOR ACCUSHOT® SPRAYER

1. Remove sprayer from side holster. Unwrap the tubing.

2. Remove seal from top of cap. Unplug cap.

3. Securely snap the plug into hole on cap.

4. Remove plastic tab near top of sprayer to activate batteries.

5. Twist nozzle to adjust spray from CLOSE to SPRAY or STREAM.

6. When priming the sprayer, hold sprayer level to the ground. Sprayer may not prime if it is

held at an angle. Once primed, it will spray in any direction.

HOW TO USE THE ACCUSHOT® SPRAYER

 Aim toward target area, and away from people and pets.
 To improve accuracy, use slider to extend wand.
 Press the trigger to spray.
 Release the trigger to stop spray.

After use:

1. Twist nozzle completely to CLOSE position.

2. Secure sprayer tip down in holster.

3. Failure to adjust nozzle completely to CLOSE position and properly secure sprayer

in holster may result in leakage and damage to property or injury to people or
animals.

TO REPLACE BATTERIES:

1. Use screwdriver to open battery compartment.

2. Remove new AA used batteries and insert four new AA batteries in correct positions as

marked per diagram inside of battery compartment. Never insert the positive end where
the negative end belongs and vice versa. Always use a complete set of new batteries of
the same type when replacing batteries. Never mix alkaline, carbon-zinc or rechargeable
batteries.

3. Securely close battery compartment door.

4. Always follow manufacturer’s recommendations for use and disposal of batteries.

ADDITIONAL OPERATING NOTES:

 Do not submerge in water.
 Before each use, inspect sprayer carefully — make sure hose is flexible and not kinked,

worn or cracked and that all connections are tight.

 When storing sprayer for prolonged periods, remove batteries.